Getting Started; Power-Up Test Sequence/Start-Up Mode - Beltronics Vector 985 Operating Instructions Manual

Laser Optical Sensors
7.
front and behind.
Audio Alert Speaker
8.
Voice Messages are emitted from this location.
Power Jack
9.
VECTOR 985 operates in any vehicle with a 13.8 volt DC
negative ground system

Getting Started

Power-Up Test Sequence/Start-Up Mode

k
Using the supplied straight or coiled power cord,
place the end with the "elbow" shaped jack into the
receptacle on the side of the detector; the opposite
end of the cord connects to the cigarette barrel. Plug
the cigarette barrel into your vehicle's cigarette plug, or the
secondary receptacle if your vehicle is so equipped. Press
the PWR button to turn the unit ON. Depending upon the
Operating Mode selected, the power up test sequence and
confirmation of Radar/Laser/SWS
you as follows:
N N O O R R M M A A L L (Factory Pre-Set Mode)
k
A lengthy, power up test sequence that displays audio
and text messages for Laser, Ka, K, X and Safety
Warning System
the General Selectable Features each time the unit is
turned on. When complete, unit is ready for
operation and will display Radar, Laser and SWS
messages when signals are detected. Normal Mode is
recommended when first using your VECTOR 985.
M M O O D D S S (Modifications Mode)
k
Presents audio and text messages for Laser, Ka, K, X
and Safety Warning System
ONLY those General Selectable Features which have
been modified by the user from their Factory pre-set
state each time unit is turned on. Unit is ready for
5 5
operation and will display Radar, Laser and SWS
messages when signals are detected.
: collect Laser signals from in
: all audible alerts and Digital
: using the straight or coiled cord,
(10.5 volt to 15.5 volt range)
®
(SWS ™ ) followed by the status of
™ alerts will be relayed to
®
(SWS ™ ), followed by
.
™
™