Digi ConnectPort X4 H Quick Start Manual
Hide thumbs
Also See for ConnectPort X4 H:
- Quick start manual (3 pages) ,
- User manual (265 pages) ,
- User manual (247 pages)
Advertisement
Quick Start Guide
ConnectPort® X4 H
1
Verify your components
Verify that you have all included equipment. If any item is missing or damaged, contact your supplier.
Note
If your device uses a SIM card, it must be supplied and activated by a cellular service provider for device operation.
2
Open the device
Unscrew and open the lid. Be sure to note that the top of the enclosure is hinged to the base on the power cord side.
© 2017 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this
document are the property of their respective owners.
Welcome to your Digi product
Get started: This guide helps you with initial product setup. Need more? Find additional
product support at www.digi.com/support/ConnectPortX4. Or connect to the online
documentation by scanning this code:
Digi Technical Support: Digi offers multiple support plans to help you get the most out of your
product. For information on Technical Support plans and pricing, contact us at 877.912.3444 or
visit www.digi.com/support.
Documentation Feedback: To provide feedback on this documentation, send your comments
to techcomm@digi.com.
Connect Port X4 H
Ethernet cable
Included equipment
Cellular/WiMAX antenna
Wire whip antenna
Advertisement
Table of Contents
Related Manuals for Digi ConnectPort X4 H
Summary of Contents for Digi ConnectPort X4 H
- Page 1 Unscrew and open the lid. Be sure to note that the top of the enclosure is hinged to the base on the power cord side. © 2017 Digi International Inc. Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this document are the property of their respective owners.
- Page 2 Note Digi recommends that you use 4 to 5 inches per pound of torque when tightening the screws. You should tighten the screws in a criss-cross pattern to ensure that the cover is not bent or skewed during this process.
Need help?
Do you have a question about the ConnectPort X4 H and is the answer not in the manual?
Questions and answers