Installing The Risers; Threading The Ropes - Balanced Body Pilates IQ Reformer Assembly Instructions Manual

4. Figure J shows the IQ in full extension
(with risers and ropes, which you will install later).
Figure J
To shorten frame, loosen the knobs, and push the frame firmly
into the shortened position. Re-tighten the knobs on either side
of the frame. Do not overtighten.
CAUTION: DO NOT move or stand the IQ unless you have
shortened the frame and re-tightened the knobs.

INSTALLING THE RISERS

1. Remove the zip ties from the risers.
2. Remove the locking pins from the frame. See figure K
3. Insert the riser into the hole angled out to the side as shown
in Figure L
4. Re-insert the riser locking pin through the frame and the
risers. The removable risers can be stored in a compartment
at the head-end of the frame.
Figure K
4
Figure L

THREADING THE ROPES

1. Attach springs so the carriage is secure.
2. Connect ropes to the large cotton loops and place the loops
over the shoulder rests
3. Refer to figure M for proper rope orientation.
4. The rope must pass through the silver rope loop, then the
cleat, and finally the other silver rope loop.
To lengthen the rope, lift it out of the cam cleat, adjust to desired
length, and then push rope back into the cam cleat. To shorten
the rope, simply pull on the free end of the rope.
Figure M
Remove locking
pins on either side
cam
cleat