Related Manuals for Blue Diamond PICKUP BROOM 2 Series
Summary of Contents for Blue Diamond PICKUP BROOM 2 Series
- Page 1 PICKUP BROOM SERIES 2 Operation and Maintenance Manual 60" - 116512 72" - 116517 84" - 116522 96" - 116527 Gutter Brush -116555 Register your WARRANTY within 30 days of purchase 888-376-7027 | BlueDiamondAttachments.com...
- Page 2 Operator’s Manual and thoroughly understand safe and correct operating, installation and maintenance procedures. Model Number: Blue Diamond is continually working to improve its products. Blue Diamond reserves the right to make Serial Number: any improvements or changes as deemed practical...
-
Page 3: Table Of Contents
CONTENTS A. SAFETY 1. General Safety 2. Safety Decals 3. Mandatory Safety Shutdown Procedure 4. Mounting and Dismounting C. OPERATION 1. Set Up 2. Attaching To Loader 3. Safe Broom Operation 4. Operating Tips-Sweeping 5. Operating Tips-Dumping 6. Operating tips - Optional Water kit 7. -
Page 4: Safety
Safety Safety Information Safe Operation Needs A Qualified Operator WARNING SAFETY ALERT SYMBOL This SAFETY ALERT SYMBOL identifies AVOID SERIOUS INJURY OR DEATH important safety messages equipment and in the owner’s manual. When Operators must receive instructions before you see this symbol, be alert to the operating the machine. -
Page 5: Safety Decals
2. Safety Decals 3. Mandatory Safety Shutdown Procedure WARNING The safety decals existing on the attachment should be clearly readable and always followed. The location of the decals is shown in the parts diagram. Replace any safety decal that is BEFORE OPERATING THIS EQUIPMENT, READ AND missing or damaged. -
Page 6: Operation
C. OPERATION to the skid steer quick couplers. WARNING • While attachment is on the ground, visually inspect quick coupler to ensure pins are extended. THE FOLLOWING PRECAUTIONS MUST BE OBSERVED Connect the wiring harness. FOR THE SAFETY OF THE OPERATOR AND BYSTANDERS. 3. -
Page 7: Operating Tips-Sweeping
4. Operating Tips-Sweeping 5. Operating Tips-Dumping WARNING Only use broom on compatible loaders. Loader flow must not exceed 25 gallons per minute. DO NOT USE high flow THE FOLLOWING PRECAUTIONS MUST BE OBSERVED hydraulics. Loader relief pressure must not exceed 3500 psi. FOR THE SAFETY OF THE OPERATOR AND BYSTANDERS. -
Page 8: General
D. MAINTENANCE WARNING FAILURE TO FOLLOW THE SAFETY PROCEDURES BEFORE CLEANING, ADJUSTING, LUBRICATING, OR SERVICING THIS UNIT COULD RESULT IN SERIOUS INJURY OR DEATH. 1. General Proper maintenance of the attachment will result in longer life and more productive and cost effective operation. There are two basic categories of maintenance, lubrication and broom wafer maintenance. -
Page 9: Removing And Replacing Motor
Fastener Torque Specifications Tighten hardware. 6. Removing and Replacing Motor Unless otherwise specified, all bolts to be torqued as follows. BOLT SIZE TORQUE (lb.-ft.) See parts diagrams for pictures. 1/4-20 UNC Place broom on the ground and perform mandatory shutdown procedure. 5/16-18 UNC 3/8-16 UNC Remove left side rubber skirt retainer. -
Page 10: Pickup Broom Series 2 Assembly
Pickup Broom Series 2 Assembly... - Page 11 Pickup Broom Series 2 Assembly...
-
Page 12: Pickup Broom Series 2 Water Kit
Pickup Broom - Water Kit ITEM NO. PART NUMBER DESCRIPTION 216673 PUMP MOUNT BRACKET 216539 PUMP HOOD 216540 PUMP 216650 PUB TANK 216655 TANK STRAP 116580 60”-SPRAY BAR KIT 116583 72”-SPRAY BAR KIT 116586 84”-SPRAY BAR KIT 116589 96”-SPRAY BAR KIT 116555 GUTTER BRUSH ASSEMBLY 299426... - Page 15 BLUE DIAMOND ATTACHMENTS liability for any defect with respect to accepted goods shall be limited to repairing the goods at a BLUE DIAMOND ATTACHMENTS designated location or at an authorized dealer location, or replacing them, as BLUE DIAMOND ATTACHMENTS shall elect. The above shall be in accordance with BLUE DIAMOND ATTACHMENTS warranty adjustment policies.
- Page 16 QUALITY | DEPENDABILITY | INTEGRITY Blue Diamond® Attachments 4512 Anderson Road, Knoxville, TN 37918 88-376-7027...
Need help?
Do you have a question about the PICKUP BROOM 2 Series and is the answer not in the manual?
Questions and answers