Quadratec Q Series Assembly And Installation Manual page 7

Remote Controller Setup
Remote
Control
Power Button
Red "Wireless"
Indicator Light
Rocker Switch
WIRELESS
MODE
blink. While the Winch Power Button
is blinking, press and hold the silver
Remote Control Power Button. The red
"WIRELESS" light on the remote will
illuminate on the controller, then after a
few seconds it will start to blink. At this
time the remote control is paired and you
can release the Remote Control Power
Button. The red light will remain lit while
it is wirelessly paired to the winch. If the
red light on the controller begins blinking
while operating the winch, the controller
is out of range or it has lost wireless
connection. Move the controller closer to
the winch until the light stops blinking.
While the winch is in Free Spool, test both
the "OUT" and "IN" functions using the
rocker switch. The winch is now ready
for use.
NOTE: Wireless handheld remote
controller will automatically shut off
after 2 minutes of inactivity and the red
indicator light will no longer be lit. If this
happens, just turn the remote on again.
Also, the winch itself is designed to
automatically stop receiving commands
after 10 minutes of inactivity. The winch
amber drum light will blink continuously
until the winch is turned off. The winch
will not receive commands from the
THE POWER BUTTON MUST BE OUT FOR WIRED
CONTROL OF THE WINCH.
THE POWER BUTTON MUST BE IN FOR WIRELESS
CONTROL OF THE WINCH.
PRESSING AND RELEASING THE POWER BUTTON
WHILE THE WINCH MOTOR IS ROTATING WILL
IMMEDIATELY STOP ROTATION.
wireless remote control or the wired
remote control until the power switch on
the winch is turned off and back on.
The Wireless Remote is paired with the
winch every time you use it, so there is no
need to clear a paired remote.
NOTE: The wireless remote will work
within a range of 10 feet from the
winch but may work farther distances
depending on physical obstructions and
other conditions. We do not recommend
using the wireless feature from the cab of
your vehicle. If you choose to winch from
the cab, please use the wired option for
safety and consistency.
7