3 608 870 F34/2017-05 | IMenip2
11
Disassembly and replacement
Required tools
• TX9 screwdriver
Disassembling
CAUTION
Disconnecting the IMenip2
interface module while un-
der voltage
Damage to the IMenip2 interface
module!
Always switch off the power
supply to the relevant system
component before removing
the IMenip2 interface mo-
dule.
Fig. 4: Releasing the lock
1 Lock
Proceed as follows to disassemble the
IMenip2 interface module:
1. Make sure the relevant system
components are not under voltage.
2. Loosen the front torx screws. The
IMenip2 interface module may only be
removed once the lock has been
completely released (see Fig. 4).
3. Assemble a dummy panel, if necessary.
1
Bosch Rexroth AG
23/28