About This Document; General Safety Instructions - Bosch Rexroth IMenip2 Installation Instructions Manual

16/28 Bosch Rexroth AG
1

About this document

This manual contains important information
on the safe and appropriate assembly, trans-
portation, commissioning, operation, mainte-
nance, disassembly and simple
troubleshooting of the IMenip2 interface
module.
Read these instructions completely, espe-
cially the chapter "2 General safety instruc-
tions" on page 16 before working with the
IMenip2 interface module.
Related documents
The IMenip2 interface module is a system
component.
Also observe the instructions for the other
system components.
Also observe the generally applicable, legal
or otherwise binding regulations of the Euro-
pean or national legislation and the rules for
the prevention of accidents and for environ-
mental protection applicable in your country.
2 General safety instruc-
tions
The IMenip2 interface module has been man-
ufactured according to the accepted rules of
current technology. There is, however, still a
danger of personal injury or damage to equip-
ment if the following general safety instruc-
tions and the warnings before the steps
contained in these instructions are not com-
plied with.
• Read these instructions completely and
thoroughly before working with the
IMenip2 interface module.
• Keep these instructions in a location where
they are accessible to all users at all times.
• Always include the operating instructions
when you pass the IMenip2 interface mod-
ule on to third parties.
IMenip2 | 3 608 870 F34/2017-05
Intended use
The IMenip2 interface module is a compo-
nent in terms of the machine directive 98/37/
EC and is not a ready-for-use machine. The
product is exclusively intended for being inte-
grated in a machine or system or for being as-
sembled with other components to form a
machine or system.
The product may be commissioned only if it is
integrated in the machine/system for which it
is designed and the machine/system fully
complies with the EC machine directive. Ob-
serve the operating conditions and perfor-
mance limits specified in the technical data.
The IMenip2 interface module is a work appli-
ance and not designed for private use.
Intended use includes having read and un-
derstood these instructions, especially the
chapter "2 General safety instructions".
The IMenip2 interface module is intended for
installation in components for the Tightening
System 350.
Improper use
Any use of the IMenip2 interface module oth-
er than described in section "Intended use" is
considered as improper.
Personnel qualifications
Assembly, commissioning and operation, dis-
assembly, service (including maintenance
and repair) require basic electrical and me-
chanical knowledge, as well as knowledge of
the appropriate technical terms. In order to
ensure operating safety, these activities may
therefore only be carried out by qualified
technical personnel or an instructed person
under the direction and supervision of quali-
fied personnel.