Installation; Turning On The Machine; First Use; Flushing The Air Out Of The Pump - Idex Fast & Fluid Management X-SMART Original Manual

Installation

4 Installation
4.1

Turning on the machine

1. Connect the power cable to the wall socket. When the
machine is operational, you hear two 'beeps'.
2. Make sure that the emergency stop switch is released.
3. Set the computer switch to 'ON'.
4. Run the dispense software.
4.2

First use

1. Fill and place the brush unit. See § 3.3.3.
2. Fill the canisters correctly. See § 3.3.5.
3. Flush all air out of the pumps. See § 4.3.
4.3

Flushing the air out of the pump

1. Flush the air out of the pump:
- Use the air flushing command in the dispense software.
- If the dispense software does have an air flushing
command option or is not able to flush the air out of the
pump automatically, dispense 120 ml / 3 oz. Repeat the
action until all air is out of the pump.
Note
For the unpacking and installation procedures,
refer to the separate installation instruction sheets.
Note
Before the first use it is important that all air is
removed from all individual pumps.
X-Smart
17
V 1.4