Equalizer Terminator TSK710 User Manual page 4

Install the mirrow inside the car to serve as a guide during the re-
pair. Using the probe, remove broken glass debris from the chip.
Use a clean dry paper towel to wipe debris away.
Clean around the damaged area with water or glass cleaner. Be sure
to place a nitrile glove-covered finger over the rock chip in order to
keep from contaminating the break. Wipe dry with the paper towel.
Install the bridge onto the glass so that the injector tip o-ring is over
the rock chip. Pump the vacuum cup to secure to the glass. Screw
the injector down until the o-ring makes contact with the surface of
the glass. Adjust the bridge posts until the o-ring has a flat look to its
appearance.
4