Appendix; Battery Set E+ Logger - Van Walt Rain Gauge Operating Instructions Manual

VAN WALT
Monitoring your needs

Appendix; Battery set e+ logger

Always replace the 3 O-rings!
11.41.90.01 Battery set
Description
e+ Battery
O-ring (d 15,6x1,78)
O-ring (d 18 x 1)
Socket-head screw wrench
Acid free vaseline
Desiccant pack
Required material:
Clean dry towel
1. Disconnect the sensor connector from the e+ logger
2. Make the outside of the e+ logger dry and clean
3. Remove the O-ring and the nut.
4. Slip the support ring, battery cover and both thin
O-rings of the e+ logger.
5. Remove the desiccant pack.
6. Remove the battery by unscrewing the
clamping screws
7. Clean the inside and the O-ring seat
There are 3 O-rings:
1 O-ring 1 —> sealing battery cover sensor-side
2 O-ring 2 —> sealing battery cover Irda-side
3 O-ring 3 —> sealing/locking protective cap
8. Place the new battery (H5.00.18.0) and secure it
with the clamping screws and clamping plates. For
the correct position of + and - see the sticker in the
e+ logger.
Attention:
for the + and -!
9. Check the functioning and configuration of the
e+ logger according to the instructions of the
e+ logger.
Van Walt Ltd | Prestwick Lane | Grayswood | Haslemere | Surrey | GU27 2DU | Tel. 01428 661 660 | Fax. 01428 656 808 | www.vanwalt.com
Operating Instructions
Rain Gauge
Art.no. Qty.
H5.00.18.0 1
H2.22.61.2 1
H2.22.62.0 2
99.75.02.05 1
H2.74.18.0 1
H2.76.41.0 1
O-ring seat
for O-ring 1
H5.00.18.0
H2.76.41.0
H2.22.62.0
H2.22.61.2
Battery cover Support ring
Clamping
screws
Clamping
screw
Connection
wire battery
Clamping
plate
Nut O-ring 3
O-ring seat
O-ring seat
for O-ring 3
for O-ring 2
22