Sony WALKMAN WM-FX877 Operating Instructions Manual page 53

On the main unit
1
Press MENU repeatedly to
move "__" (the cursor) in the
display of the main unit to the
playback mode to be adjusted.
2 Press SET repeatedly to select
the playback mode to your
choice.
Note
• If the sound is distorted when you
listen to the bass-boosted sound
with AVLS function, turn down the
volume.
Emphasizing Sound
You can choose one of the
following sound emphases using
the Menu function on the remote
control or on the main unit.
RV : Sound Revitalizer.
Emphasizes treble sound.
MB : Mega Bass.
Emphasizes bass sound
(moderate effect).
GRV : Groove.
Emphasizes bass sound (strong
effect).
NORM (no message on the main
unit) : normal (no effect).
On the remote control
1 Press MENU to enter the
menu mode. "r" will flash in
the display.
2 Jog the jog lever upward/
downward repeatedly until
"r" flashes on the sound
emphasis of your choice.
3 Press the jog lever to enter.
You will hear a short beep and
"r" will appear for a few
seconds. Then, the display will
exit the menu mode.
To display the sound emphasis
status on the remote control
Press MENU to enter the menu
mode. The active sound emphasis
will be marked by the "r".
On the main unit
1 Press MENU repeatedly to
move "__" in the display to
SOUND.
2 Press SET repeatedly to select
the sound emphasis of your
choice.
Note
• If the sound becomes distorted with
the GRV effect, select MB or NORM
(no message).
Notes on the menu mode
• You cannot operate the tape from
the remote control while you are in
the menu mode.
• When you press the jog lever to
enter, or if you leave the remote
control unoperated for more than
30 seconds, the display will exit the
menu mode automatically. To exit
the menu mode manually, press
MENU again.
• The menu setting (except for AVLS)
is stored even after the battery is
replaced.
53