Sony WALKMAN WM-FX877 Operating Instructions Manual page 52

Using the Menu
Adjusting playback
modes
You can adjust the following
playback modes using the Menu
function on the remote control or
on the main unit.
AVLS: Turn on to limit the
maximum volume to protect
your hearing (Automatic
Volume Limiter System)
(on the main unit, "
indicates "on").
BL SKIP: Fast-forwards the tape to
the next track if there is a blank
space of longer than 12 seconds
(Repeats a set of three short
beeps when skipping a blank)
(on the main unit, "
indicates "on").
a (MODE): plays both sides
repeatedly when turned on (on
the main unit, "a" is
displayed).
Plays both sides once from the
FWD side when turned off (on
the main unit, "Å" is
displayed).
a (aNR): Turn on when you
play back a tape recorded with
the Dolby* B NR system (on the
main unit, "
"on").
52
"
"
" indicates
* Dolby noise reduction
manufactured under license from
Dolby Laboratories Licensing
Corporation.
"DOLBY"and the double-D symbol
a are trademarks of Dolby
Laboratories Licensing
Corporation.
Note
• The playback modes can be set or
canceled separately.
On the remote control
1
Press MENU to enter the
menu mode. "r" (the cursor)
will flash in the display of the
remote control.
2
Jog the jog lever upward/
downward repeatedly until
"r" flashes on the playback
mode to be adjusted.
3 Press the jog lever to enter.
You will hear a short beep and
"r" will appear for a few
seconds. Then, the display will
exit the menu mode.
To cancel a playback mode
On the remote control, repeat the
above so that "r" disappears on
the playback mode to be adjusted.
To display the playback mode
status on the remote control
Press MENU to enter the menu
mode. The active playback mode(s)
will be marked by the "r".