JACK
Please note that:
❒ the jack weight is 1,76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired and in the event of a
fault it must be replaced by another original one;
❒ no tool other than its cranking device may be
fitted on the jack.
To change a wheel, proceed as follows:
❒ Stop the car in a position that is not dangerous for
oncoming traffic where you can change the wheel
safely. The ground must be flat and sufficiently
compact;
❒ switch off the engine, pull up the handbrake and
st
engage the 1
gear or reverse. Wear the reflective
safety jacket (compulsory by law) before getting
out of the car;
❒ open the luggage compartment, pull tab A fig. 142
and lift up the mat B;
❒ using the wrench A fig. 143 located in the tool
box, loosen the locking device, take the tool box B
and place it close to the wheel to be replaced.
Then take the space-saver wheel C;
❒ take the wrench A fig. 144 and loosen the fixing
studs by about one turn. For versions with alloy
rims, shake the car to facilitate detachment of the
rim from the wheel hub;
❒ take the wedge A from the tool box and open it as
shown in the diagram in fig. 145;
fig. 142
fig. 143
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
F0Y0083
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0Y0096
177