Table of Contents
Advertisement
3.0 Operation
The machine must be adjusted again for each tube dimension. Then the feed rate and
direction are set.
3.1 Selection of support
For each tube dimension, the machine must be adjusted again. The tube dimension
determines the support to be used in frame. Below the fork is mounted support roller
(A) and Teflon support plate (B) respectively.
Diagram 3.1: The two supports. (A= Support roller B= Support Teflon)
The two scales located on the fork indicate where the support should be placed in
relation to tube dimension. The support roller is used for the largest pipe dimensions
10
Advertisement
Table of Contents
