Related Manuals for Agrimate AMWL-432
Summary of Contents for Agrimate AMWL-432
- Page 1 AMWL-432 ROTARY POWER WEEDER WET LAND DISCLAIMER: DUE TO CONSTANT UPGRADATION, FEATURES AND SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE BEFORE OPERATING THIS MACHINE, PLEASE READ THESE INSTRUCTIONS CAREFULLY...
-
Page 2: Safety Precautions
SAFETY PRECAUTIONS NOTE: These instructions are for your protection. Please read them carefully. TRAINING Before using your for the first time, read the entire Owner's Manual carefully. It is important to be thoroughly familiar with the controls and the proper use of the equipment. Never allow children to operate the equipment. -
Page 3: Maintenance And Storage
6. Stop the engine whenever you leave the operating position. Also disconnect spark plug wire before unclogging the tmes and when making any repairs, adjustments, and inspections. 7. Take all possible precautions whenever you leave the machine unattended. Always stop the engine. -
Page 4: Putting It All Together
DIAGRAM OF AMWL-432 PUTTING IT ALL TOGETHER 1. Mounting the floater by M8*L20 bolt 4pcs. - Page 5 2. Mounting the cutting blade on the shaft by pin set .
- Page 6 3. Put the handle and mudguard to the connector, fix the left supporter , right supporter, handle to the connector by M6*L90 bolts and nut , then fix the mudguard to the left supporter and right supporter by M6*L12 bolts, M6 nut, and washer. 4.
- Page 7 CONNECTING THE THROTTLE LINKAGE a. Slide the throttle wire through the cable adjuster . Line up the "slotted" swivel with the wire, making sure the hole for the wire end is opposite the cable adjuster. (See arrow.) b. Once the throttle wire is attached to the carburetor, locate the other end of the throttle wire and insert the wire end into the throttle lever hole.
-
Page 8: Operating Controls
OPERATING CONTROLS NOTE. Fig. 11 shows the location of the operating controls of your WEEDER. For your safety, we strongly recommend that you become familiar with their functions before using the machine. WARNING- KEEP ARMS AND LEGS AWAY FROM ROTATING TINES. ROTATING TINES CAN CAUSE INJURY. - Page 9 If The Engine Does Not Start 1. If the engine starts but does not continue to run, repeat steps under Cold Starting. 2. If the engine cranks but does not fire, squeeze the throttle lever and repeat steps under Warm Starting. ...
-
Page 10: Maintenance
MAINTENANCE FIG.13 1. (FIG. 13) Air Cleaner ñ The air cleaner elements must be removed and cleaned every twentyfive hours or at the beginning of each season. More frequent cleaning is recommended under very dusty conditions. Thoroughly wash the elements in liquid detergent and water. Press the elements in a rag until they are completely dry, saturate them in 2-cycle oil or the equivalent. - Page 11 3. (FIGS. 15 & 16) Muffler/Exhaust Port/Cylinder - At the end of each season (or after 25 hours of use) the muffler must be removed and cleaned to prevent carbon accumulation. At the same time, the exhaust port should be cleaned.
- Page 12 5. General Maintenance Items - Good preventative maintenance habits will prolong the life of your E-Z Tiller. We recommend the following checks after each use: check screws, (1) IDLE SPEED nuts, and bolts for tightness; check fuel lines ADJUSTMENT and connections for leaks; inspect and clean SCREW fender, tines, and the gear case.
-
Page 13: Specifications
1. It's a good idea to perform the following storage procedures at the end of the season or if your WEEDER won't be used for more than thirty days: 2. Remove all fuel from the fuel tank to prevent gum deposits from forming and causing possible malfunction of the engine. -
Page 14: Troubleshooting
TROUBLE SHOOTING Engine Won't Start a. Engine does not turn over Switch not on - Check Start Switch b. Engine turns over Incorrect Starting Procedure - See Page 8 No spark on spark plug - Clean and re-gap plug (see pg 10) or replace Not enough fuel - Add fuel Fuel is old or incorrect... - Page 15 PLOUGHING MACHINE ASSEMBLY ROTARY POWER WEEDER WET LAND TRANSMISSION SPARE PARTS SL. NO. Part Number Part Name AMWL-432-1 Clutch case assembly AMWL-432-2 Socket head bolt AMWL-432-3 Connecting seat AMWL-432-4 washer AMWL-432-5 AMWL-432-6 Transmission shaft AMWL-432-7 Ogalloy ass'y AMWL-432-8 Aluminum pipe...
- Page 16 AMWL-432-10 Oil Seal AMWL-432-11 Copper spacer AMWL-432-12 washer AMWL-432-13 bearing AMWL-432-14 Worm AMWL-432-15 Washer AMWL-432-16 Floater front holder AMWL-432-17 socket cap screw AMWL-432-18 Floater AMWL-432-19 Worm wheel AMWL-432-20 Washer AMWL-432-21 Copper spacer AMWL-432-22 Framework Oil Seal AMWL-432-23 Right gearbox AMWL-432-24...
- Page 17 AMWL-432-43 Stander AMWL-432-44 Grip AMWL-432-45 Throttle cable AMWL-432-46 socket cap screw AMWL-432-47 Engine AM432 ENGINE ASSEMBLY...
- Page 18 ROTARY POWER WEEDER WET LAND ENGINE SPARE PARTS Sl.NO. Part Number Parts Name AM432-1 bolt AM432-2 cylinder cover AM432-3 spark plug AM432-4 cylinder AM432-5 screw AM432-6 cylinder gasket AM432-7 piston ring AM432-8 piston AM432-9 clip AM432-10 piston pin AM432-11 needle cage AM432-12 intake gaskter AM432-13...
- Page 19 Sl.NO. Part Number Parts Name AM432-31 washer AM432-32 AM432-33 ignition coil AM432-34 cable AM432-35 fly wheel AM432-36 screw AM432-37 location pin AM432-38 crankcase fly wheel side AM432-39 laction pin AM432-40 oil seal AM432-41 bearing AM432-42 o-ring AM432-43 woodruff key AM432-44 crankshaft assembly AM432-45 oil seal...
-
Page 20: Inspection And Maintenance
INSPECTION & MAINTENANCE For safety use, make sure the machine is cleaned every three-months. Before working, make sure to inspect the filter and the nozzle,and ensure there is no impurity. After working, make sure there is no water in the pump and the hose. If the machine needs to be repaired in the guarantee period, please return the machine to the shop. - Page 21 Warranty Card CUSTOMER COPY Purchaser’s Name & Address Date of Delivery Dealer’s Office Seal Product Name AMWL-432 Rotary Power Weeder Wet Land Product Serial No. Dealer Sign Customer Sign. Invoice / DN No. I/We accept the terms and conditions of Warranty as in the Warranty Card.
- Page 22 1. LIMITED WARRANTY PERIOD : For a period of six months from the date of Sale / delivery of the product which ever is earlier. 2. LIMITED WARRANTY OBLIGATION : Replacement of defective part(s) by authorized dealer are free of charges. If found defective by reasons of defective material / poor workmanship, parts will be replaced and there will be no value re-imbursement.
- Page 23 1st Free Service Coupon ISO 9001-2008 CERTIFIED COMPANY FREE SERVICE COUPON (30 Days / 20 hrs (Which ever is earlier) Model Serial Number AMWL-432 Rotary Power Weeder Wet Land PDI Date Purchase bill no. Date Service No. Operations: • Check and Test the Fuel Mixture.
- Page 24 Small Maintenance. Big Savings. Small Maintenance. Big Savings. Small Maintenance. Big Savings.
- Page 25 Do’s Don’ts • Always read the instruction manual supplied along with the equipments and understand the correct installation and operating procedures before attempting to use the equipments. • It is important to use the personal protection equipments such as head helmet with visor, ear defenders, goggles, safety gloves, cut resistant shoes, trousers and jackets while operating potentially dangerous machines.
- Page 26 Agrimate Army For Pest Control ANY WHERE - ANY TIME - ANY CROP RATNAGIRI IMPEX PVT LTD Annapurna House, #1/1G, 7th Cross, New Guddadahalli Mysore Road, Bangalore-560 026 Customer Care: 1800-425-7475 email: customercare@ratnagiriimpex.com www.ratnagiriimpex.com AN ISO 9001:2008 CERTIFIED COMPANY...
Need help?
Do you have a question about the AMWL-432 and is the answer not in the manual?
Questions and answers