INSTALLATION INSTRUCTIONS
06-9523SP
ASTRAL TUB SPOUT
THIS FAUCET MEETS OR EXCEEDS THE FOLLOWING STANDARDS:
cUPC, ASME A112.18.1
THANK YOU FOR PURCHASING THIS TAYMOR PRODUCT. ALL TAYMOR PRODUCTS ARE CAREFULLY
ENGINEERED AND FACTORY TESTED TO PROVIDE LONG TROUBLE-FREE USE UNDER NORMAL CONDITIONS.
HAVE BASIC TOOLS READY
RECOMMENDED TOOLS:
Teflon
Screw-
Adjustable and
Hand
drill
tape
drivers
Pipe wrench
WARNING: READ ALL the instructions completely before beginning.
READ ALL warnings, care and maintenance information.
Taymor recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and provincial plumbing and building codes.
Need Help? Please call our toll-free Customer Support line at
(WEST) 1-800-267-4774
(EAST ) 1-800-387-7064 for additional assistance or service.
TURN OFF THE MAIN WATER SUPPLY
Locate water supply inlets and shut off water supply valves.
TURN OFF
Flashlight
Torque
Safety
Plumber's
goggles
putty
wrench
TURN OFF
1
The minimum distance between the
center of the tub spout and the rim
of the tub should be no less than 4".
2
The stub out for the 1/2" pipe
should extend a minimum of 1-5/8"
from the wall, but not to exceed
3-1/2" from the wall. Remove all
burs and sharp edges from the stub
out 1/2" pipe.
Silicone
caulk
3
Slide the spout
1
over exposed
stub out pipe until flush to the wall.
Center the spout
1
and tighten the set screw
underneath with Allen Wrench
(Hex 2.38 mm) provided.
4
EXPLODED DIAGRAM FOR REFERENCE
MAINTENANCE Your new faucet is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners,
steel wool and harsh chemicals as these will dull the finish and void your warranty.
SPOUT
CUSTOMER SERVICE
WEST 1-800-267-4774 | EAST 1-800-387-7064 | taymor.com
1-5/8" to 3-1/2"
on the wall
2
from
1
LONG SHANK
RETAINER
FLANGE
SCREW
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
4" MINIMUM
2
O-RING
CONNECTOR
O-RING
WASHER