Dyson V8 Absolute+ Gold Operating Manual page 39

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 38
WASHING THE FILTERS
Your appliance has two washable filters; wash the filters at least once a month
according to the following instructions to maintain performance. More frequent
washing may be required where the user: vacuums fine dust, operates mainly in
'Powerful suction' mode, or uses the machine intensively.
WASHING FILTER A
Ensure the appliance is disconnected from the charger before removing the filter.
Be careful not to pull the 'ON' trigger.
Check and wash the filter regularly according to instructions to
maintain performance.
The filter may require more frequent washing if vacuuming fine dust or if used
mainly in 'Powerful suction' mode.
To remove the filter, lift it out of the top of the appliance.
Wash the filter with cold water only.
Run water over the outside of the filter until the water runs clear.
Squeeze and twist with both hands to make sure the excess water is removed.
Leave to dry completely for a minimum of 24 hours.
Do not put any part of your appliance in a dishwasher, washing machine, tumble
dryer, oven, microwave or near a naked flame.
To refit, place the dry filter back into the top of the appliance. Make sure it is seated
properly.
WASHING FILTER B
To remove the filter, twist anti-clockwise to the open position and pull away from
the appliance.
Wash the inside of the filter under cold running water, rotating the filter to ensure all
pleats are covered.
Gently tap the filter against the side of the sink several times to remove any debris.
Repeat this process 4-5 times until the filter is clean.
Place the filter upright, with the top of the filter facing upwards, and leave to dry
completely for a minimum of 24 hours.
To refit, return the filter to the open position and twist clockwise until it clicks
into place.
WASHING THE LIGHT PIPE CREVICE TOOL
Wash the Light pipe crevice tool with cold water.
Wash frequency depends on how often its is used or the environment.
Make sure the Light pipe crevice tool is completely dry before using.
BLOCKAGES – AUTOMATIC CUT-OUT
Your machine is fitted with an automatic cut-out.
If any part becomes blocked, the machine may automatically cut out.
This will happen after the motor pulses a number of times (i.e switches on and off in
quick succession).
Leave to cool down before looking for blockages.
Ensure that the appliance is disconnected from the charger before looking for
blockages. Failure to do so could result in personal injury.
Make sure any blockages are clear and all parts are refitted before using
your machine.
Refit all parts securely before using.
Clearing blockages is not covered by your guarantee.
LOOKING FOR BLOCKAGES
The motor will pulse when there is a blockage. Please follow the instructions below
to locate the blockage:
Ensure that the appliance is disconnected from the charger before looking for
blockages. Be careful not to pull the 'ON' trigger.
Do not operate while checking for blockages. Doing so could result in
personal injury.
Beware of sharp objects when checking for blockages.
To check for blockages in the main body of the appliance, remove the clear bin and
cyclone as per the instructions in the cleaning the clear bin section and remove the
blockage. Please consult the 'Stubborn blockages' section of the illustrations for
further guidance.
If you cannot clear an obstruction you may need to remove the brush bar. Use
a coin to unlock the fastener marked with a padlock. Remove the obstruction.
Replace the brush bar and secure it by tightening the fastener. Ensure it is fixed
firmly before operating the appliance.
Your machine has carbon fibre brushes. Take care if coming into contact with
them, as they may cause minor skin irritation. Wash your hands after handling
the brushes.
Refit all parts securely before using.
Clearing blockages is not covered by your guarantee.
CHARGING AND STORING
This appliance will switch 'OFF' if the battery temperature is below 3°C
(37.4°F). This is designed to protect the motor and battery. Do not charge the
appliance and then move it to an area with a temperature below 3°C (37.4°F) for
storage purposes.
To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
Avoid using the machine with the battery flush to a surface. This will help it run
cooler and prolong battery run time and life.
BATTERY SAFETY INSTRUCTIONS
If the battery needs replacing, please contact the Dyson Helpline.
Use only Dyson chargers for charging this Dyson appliance.
The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery, do not touch the
liquid and observe the following precautions:
Skin contact – can cause irritation. Wash with soap and water.
Inhalation – can cause respiratory irritation. Expose to fresh air and seek
medical advice.
Eye contact – can cause irritation. Immediately flush eyes thoroughly with water for
at least 15 minutes. Seek medical attention.
Disposal – wear gloves to handle the battery and dispose of immediately, following
local ordinances or regulations.
CAUTION
The battery used in this machine may present a risk of fire or chemical burn if
mistreated. Do not short contacts, heat above 60°C (140°F) or incinerate. Keep
away from children. Do not disassemble or dispose of in fire.
LOOKING AFTER YOUR DYSON MACHINE
Do not carry out any maintenance or repair work other than that shown in your
Dyson User manual, or advised by the Dyson Helpline.
Only use parts recommended by Dyson. If you do not, this could invalidate
your guarantee.
Store the appliance indoors. Do not use or store it below 3°C (37.4°F). Ensure the
appliance is at room temperature before operating.
Clean the appliance with a dry cloth only. Do not use any lubricants, cleaning
agents, polishes or air fresheners on any part of the appliance.
CHARGING AND STORING
This appliance will switch 'OFF' if the battery temperature is below 3°C
(37.4°F). This is designed to protect the motor and battery. Do not charge the
appliance and then move it to an area with a temperature below 3°C (37.4°F) for
storage purposes.
To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
Avoid using the machine with the battery flush to a surface. This will help it run
cooler and prolong battery run time and life.
ONLINE SUPPORT
For online help, general tips, videos and useful information about Dyson.
www.dyson.com/support
DISPOSAL INFORMATION
Dyson products are made from high grade recyclable materials. Recycle
where possible.
The battery should be removed from the machine before disposal.
Dispose of or recycle the battery in accordance with local ordinances
or regulations.
Dispose of the exhausted filter in accordance with local ordinances or regulations.
This symbol indicates that this machine should not be disposed with your general
household waste. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. When this machine has reached the end
of its serviceable life, please take it to a recognised WEEE (Waste Electrical and
Electronic Equipment) collection facility such as your local civic amenity site for
recycling. Your local authority or retailer will be able to advise you of your nearest
recycling facility.
DYSON CUSTOMER CARE
After registering your two-year guarantee, your Dyson machine will be covered
for parts and labour (excluding filters), for two years from the date of purchase,
subject to the terms of the guarantee. If you have any queries regarding your Dyson
machine, visit www.dyson.com for online help, general tips and useful information
about Dyson.
Alternatively, you can call the Dyson Helpline with your serial number and details of
where and when you bought the machine.
If your Dyson machine needs a repair, call the Dyson Helpline so we can discuss
the available options. If your Dyson machine is under guarantee, and the repair is
covered, it will be repaired at no cost.
LIMITED 2-YEAR GUARANTEE
TERMS AND CONDITIONS OF THE DYSON 2-YEAR LIMITED GUARANTEE
ARE SET OUT BELOW. THE NAME AND ADDRESS DETAILS OF THE DYSON
GUARANTOR FOR YOUR COUNTRY ARE SET OUT ELSEWHERE IN THIS
DOCUMENT – PLEASE REFER TO THE TABLE SETTING OUT THESE DETAILS.
WHAT IS COVERED
The repair or replacement of your Dyson machine (at Dyson's discretion) if it is
found to be defective due to faulty materials, workmanship or function within
two years of purchase or delivery (if any part is no longer available or out of
manufacture, Dyson will replace it with a functional replacement part).
Where this machine is sold outside of the EU, this guarantee will only be valid if the
machine is used in the country in which it was sold.
Where this machine is sold within the EU, this guarantee will only be valid (i) if the
machine is used in the country in which it was sold or (ii) if the machine is used in
Austria, Belgium, Denmark, Finland, France, Germany, Ireland, Italy, Netherlands,
Norway, Poland, Spain, Sweden, Switzerland or the United Kingdom and the same
model as this machine is sold at the same voltage rating in the relevant country.
WHAT IS NOT COVERED
Dyson does not guarantee the repair or replacement of a product where a defect is
the result of:
Accidental damage, faults caused by negligent use or care, misuse, neglect,
carelessness or operation or handling of the machine which is not in accordance
with the Dyson User manual.
Use of the machine for anything other than normal domestic household purposes.
Use of parts not assembled or installed in accordance with the instructions
of Dyson.
39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

V8 motorheadV8 absolute+Sv10

Table of Contents