Troubleshooting Guide
Otolift Line
Have a look at the arm display.
What does it say?
LIFT
The lift is switched on and is ready to go.
READY
The lift is switched off.
SWITCHED
1. Check that the KeySwitch is on.
OFF
2. Check that the Power ON/OFF Switch is on.
The lift is not charging.
OFF
CHARGE
1. Check the Charger is switched on.
AND
2. If Hinge model, make sure lift is parked.
BEEPING
There is no power to the lift.
1. Check that the Charger is switched on.
2. Check that the Power ON/OFF Switch is on.
TILTED
The downside arm is not lowered into position.
ARM
The Holding Switch is activated.
HOLDING
SWITCH
Check the switch on the arm.
The seat is in the swivelled position. Return the
SEAT
SWIVEL
seat to the travel position.
The Hinge is open. The folding rail section is not
HINGE
OPEN
in the down position. Only on Hinge model.
Try to run the lift in the UP direction:
The lift is moving up. The lift is
MOVING
operated by the Joystick or Remote
UP
Control.
ARRIVED
Lift has arrived at the top of the rail.
TOP
There is an obstruction on the
UP
upside foot-rest edge. Check
FOOTREST
footrest is clear.
There is an obstruction on the drive
UP
unit cover. Check that the cover is
CHASSIS
clear.
There are multiple calls present, i.e.
MULTIPLE
a Remote Control is pressed at the
CALLS
same time as the Joystick.
Technician Required. Please call your local dealer:
BATTERY
MOTOR
BRAKE
CRITICAL
FAULT
FAULT
OVER
FINAL
SERVICE
SPEED
LIMIT
DUE
Try to run the lift in the DOWN direction:
The lift is moving down. The lift is
MOVING
operated by the Joystick or Remote
DOWN
Control.
Lift has arrived at the bottom
ARRIVED
BOTTOM
of the rail.
There is an obstruction on the
DOWN
downside footrest edge or underpan.
FOOTREST
Check footrest is clear.
There is an obstruction on the drive
DOWN
unit cover. Check that the cover is
CHASSIS
clear.
There are multiple calls present, i.e.
MULTIPLE
a Remote Control is pressed at the
CALLS
same time as the Joystick.
RELAY
OVER
FAULT
CURRENT
THERMAL
CUTOUT
www.otolift.com
Need help?
Do you have a question about the Otolift Line and is the answer not in the manual?
Questions and answers
La seggiolina è bloccata in posozione di non ricarica e la lucetta sul poggiolo lampeggia velocemente,perche?
The OTOLIFT Line chair is stuck in a non-charging position with the light on the footrest flashing quickly because there is an obstruction on the footrest or underpan. To resolve this, check that the footrest and underpan are clear of any objects. If the issue persists, ensure that the charger is switched on and that the lift is properly parked if it is a hinge model.
This answer is automatically generated
Flashing orange light at back of seat
The chair is stuck in a non charging position with a 199 message on the armrest display. Can someone give support?
To fix the OTOLIFT chair stuck in a non-charging position with a 199 message on the armrest display, follow these steps:
1. Check if the seat is in the correct travel position (not swivelled).
2. Ensure the folding rail hinge is fully down if using a hinge model.
3. Confirm the armrest Holding Switch is not stuck or activated incorrectly.
4. Make sure there are no multiple calls from both the remote and joystick at the same time.
5. Verify the keyswitch and main power switch are turned on.
6. Check the charger to ensure it is properly connected and powered.
If the issue continues, contact a technician or your local dealer.
This answer is automatically generated
montascale OTOLIFT MOD. TWO, bloccato a 5 mt. dal punto di ricarica, come posso portarlo manualmente in zona ricarica.
MOD.TWO N° serie ITA 221413, bloccato a metà percorso, alimentazione OK, ma non da segni di vita, probabilmente batterie scariche per erroneo posizionamento su punto di ricarica, cosa devo fare per portarlo su un punto di ricarica.