NJD Electronics SPECTRE User Manual page 9

User Guide
To set a DMX address, add up the numbers of all the switches
that are ON and add 1 to give the DMX address. For instance to
set DMX address 41, set switch 32 on and switch 8 on, and all
other switches off: 32+8+1 = 41.
The Brightness will then be controlled by DMX Channel 42
The Colour will then be controlled by DMX Channel 43
The Saturation will then be controlled by DMX Channel 44
In 3-channel mode, the sliders operate the Spectre as follows:
The colour is continuously variable: for example, orange will be
found mid-way between red and yellow, and purple between blue
and magenta.
The saturation control allows every pastel shade between the
deepest possible colour ("fully saturated") and white to be
selected.
To set up the Spectre, set the saturation control to zero, then set
the brightness to the level required, and then set the colour. If a
paler shade of the colour is required, increase the saturation
control as required.
DMX remote control (SFC2).
Connect the DMX remote control unit to the Spectre using an
RJ11 lead. If controlling more than one Spectre, then
connect using 5-pin XLR connectors: Connect a DMX lead from
DMXout on the first lantern (the one with the remote control
connected) to DMXin on the second, from DMXout on the
second to DMXin on the third, and so on. A terminator is not
necessary, but may be fitted.
Set the DIL switches as follows: (Set both MODE switches off)
Lantern
number
1
2
3
4
© N.J.D. Electronics 1998
DMX
address
1
9
17
25
Switches on
(all other switches off)
none
8
16
8, 16
Spectre
-Page 9-