NJD Electronics SPECTRE User Manual page 14

User Guide
To set up the Spectre, set the saturation control to zero, then set
the brightness to the level required, and then set the colour. If a
paler shade of the colour is required, increase the saturation
control as required.
Chroma HX Emulation mode.
In this mode the Spectre will emulate the Chroma HX, allowing it
to be mixed with the Chroma HX in an installation, providing a
floodlighting effect in identical colour when the Chroma HX
produces a spotlight effect. (Split colours are not available on the
Spectre). Chroma mode is the most suitable when using with the
IQ-MX60 and IQ-MX80 controllers. Set the mode switches ON-
OFF for Chroma mode.
Setting the address switches.
Lantern
number
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Operation from the IQ-MX80 (or IQ-MX60)
If operating from the IQ-MX80 controller, use the Chroma mode.
The colour pads will operate, and the vertical movement of the
Joystick will control the Brightness. (It is also possible to use the
DMX 3-channel mode, although the colours will not match those
printed on the panel. In this mode, the gobo selections can be
used to set the saturation of the colour)
© N.J.D. Electronics 1998
DMX
address
1
9
17
25
33
41
49
57
65
73
81
89
97
105
113
121
Switches on
(all other switches off)
none
8
16
8, 16
32
32, 8
32, 16
32, 16, 8
64
64, 8
64, 16
64, 16, 8
64, 32
64, 32, 8
64, 32, 16
64, 32, 16, 8
Spectre
-Page 14-