NJD Electronics SPECTRE User Manual page 10

User Guide
The Spectre is provided with Midi in and Midi through connectors.
It can be connected to other midi equipment using standard Midi
leads. When the Spectre is switched on the led will light red, and
when it receives a valid midi command it will flash yellow.
MIDI
When changing from DMX operation to
Midi operation, after setting the MODE
switches, turn the mains power off, wait
ten seconds, and turn the power back on
again. Both mode switches should be ON for Midi operation.
To set the channel and controller number, the function of the DMX
address switches is changed, and are used as shown. The
spectre may be used on any Midi channel from 9 to 16, and on
any group of four controllers. Set the Midi channel as follows:
Midi Channel
9
10
11
12
13
14
15
16
(Add up the numbers of the switches, and add nine to get the Midi
Channel)
Set the Midi controller number as follows
Controller number
0 - 3
4 - 7
8 - 11
12 - 15
16 - 19
20 - 23
24 - 27
© N.J.D. Electronics 1998
MIDI
Channel Switches on
(all other channel switches off)
None
1
2
2, 1
4
4, 1
4, 2
4, 2, 1
Controller Switches on
(all other controller switches off)
None
4
8
8, 4
16
16, 4
16, 8
Spectre
1 2 4 4 8 16 32 64
Channel Controller
Number
Number
-Page 10-