NJD Electronics SPECTRE User Manual page 13

User Guide
on the second Spectre to the DMXin socket on the third, and so
on. The unit with the analogue inputs connected is called the
MASTER, and the other units are called SLAVES.
Setting the DIL switches
For single operation, set the MODE switches OFF and all other
switches ON as shown on the rear label.
If controlling a number of Spectres from one analogue input
by connecting them together using a DMX lead as described
above, set the DIL switches on the MASTER as shown on the label
(both mode switches OFF, all address switches ON, and set the
DIL switches on the SLAVES as follows:
Master
Slave #1
Slave #2
Slave #3
The 0-10V inputs operate the Spectre as follows:
The colour is continuously variable: for example, orange will be
found mid-way between red and yellow, and purple between blue
and magenta.
The saturation control allows every pastel shade between the
deepest possible colour ("fully saturated") and white to be
selected.
© N.J.D. Electronics 1998
Mode switches
OFF-OFF
OFF-ON
OFF-ON
OFF-ON
Brightness
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%
Address switches
All ON
8 on (all others OFF)
16 on (all others OFF)
16,8 on (all others OFF)
Colour
red
magenta
blue
cyan
green
yellow
red
Spectre
Saturation
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
100%
-Page 13-