Krups 3MIX9000 Series Instructions Manual page 16

KR_COMBI-BATTEUR_3MIX9000_EO_2551060 04/01/12 16:31 Page20
English
Do not clip on the base (c5) from below (fig. 19).
Position your mixer vertically then insert the adaptor (c1) into the corresponding holes turning slightly
until it locks completely (fig. 20).
Place the 2.5 l container under the vegetable cutter to collect the food (fig. 21).
Connect the appliance to the mains socket.
3.2 U
SE
Place the food into the feeder tude, guiding them using the pusher (c3) (fig. 22).
Set the button to maximum speed.
3.3 D
ISASSEMBLY
Disconnect the appliance.
To disassemble the drum holder (c2), press the button (c6) located at the front of the adaptor and
remove the feeder tube (fig. 23).
Press the button (c7) at the rear to release the adaptor (c1) from the mixer (fig. 24).
Remove the base (c5) by sliding it along the runners located at each side of the adaptor (c1) then the
drum holder (c2).
3.4 C
LEANING
The drum holder (c2), drums (c8 c9 c10 c11 c12), drum locking ring (c4) and the pusher (c3) are dis-
hwasher safe.
The mixer and the adaptor must be washed with a damp cloth.
Note:
• Always use a plunger to guide the food into the feeder tube, never your fingers, nor a fork, spoon, knife
or any other object.
• When putting away your vegetable cutter, you can slide the base over the feeder tube. (fig. 25).
4 -
BLENDER ATTACHMENT ACCESSORY: mix, emulsify (depending on model)
4.1 A
SSEMBLY
To insert the blender attachment (d1), open the rear hatch (a5) (fig. 8).
Insert the blender attachment and screw tightly (fig. 26).
Connect the appliance.
4.2 U
SE
Depending on the type of preparation, place the ingredients in the container provided (1 l bowl (e) or 2.5
l bowl (f) (depending on the model) or in a suitable container (bowl or beaker, preferably deep).
The container must be filled to the maximum or two-thirds full to prevent spilling.
Place the blender attachment (d1) into the preparation before turning on the appliance, this will prevent
splashes (fig. 27).
When you blend directly in a container, remove the container from the heat source when mixing hot pre-
parations.
The food must cover at least the lower part of the blender attachment to guarantee effective functioning.
Turn on by pressing the button (a4) (fig. 28).
Release the button (a4) before removing the blender attachment (d1) from the preparation to prevent
splashes.
Practical advice:
• Never operate the blender attachment when empty.
• For fruit preparations, chop and deseed the fruit first.
• Do not use the blender attachment with hard food such as ice, sugar, coffee grains, cereals and chocolate.
4.3 D
ISASSEMBLY
Disconnect the appliance.
Unscrew the blender attachment (fig. 29).
20