Use Of The Power Assist; Activating The Power Assist - Sunrise Medical Empulse WheelDrive User Manual

12
4

Use of the power assist

4.1 First use
One battery pack contact is protected with a
small rubber part to prevent discharge. Take out
the battery pack and remove this part before
activating the power assist (figure 3).

4.2 Activating the power assist

In order to use the power assist, both wheels
(left and right) should be turned on (figure 4)
A. Power On/Off button
B. 3 Profile buttons, button 1 is the first button
pointing to the front of the wheelchair
C. Battery indicator
A. Power On/Off button
Switch the power assist on by pushing the Power On/Off button on the user interface. You will hear
one short beep. Switch it off again by pushing the Power On/Off button a second time. You will hear
one longer beep.
B. Profile buttons front, middle and rear
The power assist has 3 driving profiles: I, II, III, Each profile and support level -with specific driving
characteristics- can be selected by pushing the appropriate button on the user interface.
When choosing profile I, the orange LED below button B1 will light up. When choosing profile II, the
orange LED's below button B1 and B2 will light up. When choosing profile III, all 3 LED's will light up.
An appropriate driving profile and speed should be chosen depending on the user's needs and safety.
left wheel
A
WheelDrive Rev.G
right wheel
B1
C
B2
B3
3
4
A