Test Function - Nicols STROB 3000 DMX User Manual

BF-04D provides:
Slider control for chase speed and intensity
-
Momentary push button control of the blinder effect, when the LED of BLACKOUT is on, that
-
means chase is stop
Momentary push button for single flash and flash synchronization, when the LED indicator of
-
BLACKOUT is on, that means chase is stop
Chase number toggle switch
-
Chase mode toggle switch: AUTO/SOUND
-
DATA CONNEXION
Important! Do not terminate the data link when using the BF-04D
The remote controller connects to STROB 3000 DMX with a 3-pin XLR data cable. Additional devices
may be connected in series, output to input. Note, however, that the data link must not be terminated as
described DMX controllers and the STROB 3000 DMX should change to the remote control function.
OPERATION
Intensity: flash intensity is controlled from 20% of the maximum Intensity to 100% of the maximum
Intensity with the DIMMER fader. The maximum intensity is reduced in low power mode, which is
selected on pin 6 of the MODE dipswitch.
Chase Speed: chase speed is controlled from slow to fast with the SPEED fader. The BLACK OUT
button toggles chase run on and off. The indicator diode is on when chase stopped and off when chase
running.
Chase Number: toggle Chase number with Chase button and will be shown on the nixie tube.
Chase Mode: toggle Chase running way with MODE button: AUTO/SOUND mode. The corresponding
LED indicator will display the selected mode.
Blind Effect: the blinder effect is controlled with the FULL ON button. The intensity is the maximum
Intensity. Lamp power is electronically regulated to prevent the lamp from overheating.
Single Flash: single flashes can be achieved by pressing the SINGLE FLASH button. Switch on the
"BLACK OUT" and indicator lamp light up, to press the SINGLE FLASH button for triggering a single
flash effect.
H. TEST FUNCTION
Start operating TEST function when set pin 3 of the MODE dipswitch to ON. No matter if STROB 3000
DMX has DMX512 signal input from controller, it will automatically test the light intensity/speed and
blind effect of the lamp.