How To Control The Unit; Master/Slave Built-In Programmed Function - Nicols BIRDY WASH 122 Manual

In the main functions, hold Enter button for at least 3 seconds into offset mode, use DOWN
and UP button up to chose Pan Offset or Tilt Offset, pressing ENTER button and the
display will blink. Use DOWN and UP button to adjust the home position of the Pan, Tilt,
Once the position has been selected, press the ENTER button to setup, to go back to the
functions without any change press the MENU button again. Hold and press the MENU
button about one second or wait for one minute to exit the menu mode.

4. How To Control The Unit

You can operate the unit in two ways:
1. Master/slave built-in preprogram function
2. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effect at once. Every time you turn the unit on, it will show "LED 12" on the
display and move all the motors to their 'home' position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built in
programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode Show Mode and select
show 1 or show 2 or show 3 or show 4 mode. Its DMX input jack will have nothing plugged
into it, and Its master LED will be constantly on and sound LED will flash to the music. The
other units will have to set in slave mode and select Slave 1 (normal) or Slave 2 (2 light
show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the
slave led lights will constantly on.
2-light show
In slave mode, Slave 1 means the unit works normally and Slave 2 means 2-light show. In
order to create a great light show, you can set Slave 2 on the second unit to get contrast
29B