Function Settings - Nicols X-RAY LASER User Manual

The system only accepts the DMX 512 signal to control the system mode: the laser pattern ON/OFF, the size, the position and the
speed.
DMX Control Parameters Chart
Channel Function
CH1 Mode
CH2 Dimmer
CH3 Pattern Select 0～255
CH4 Moving-Y
CH5 Moving-X
CH6 Rolling-X
CH7 Rolling-Y
CH8 Rotation
CH9 Zoom(+/-)
CH10 Pattern Size
CH11 Display Dot
CH12 Drawing

FUNCTION SETTINGS

If it is set to ILDA mode (use PC software to control laser light), just need to connect ILDA signal to DB25 jack. If set to built-in program,
then ILDA signal cannot be connected, setting dipswitches directly is OK. ILDA mode (PC control) and built-in program mode can be
identified and transisted automatically.
0＝OFF 1=ON X=OFF or ON
DIPSWITCH CHART
#1 #2 #3 #4 #5 #6
0 0 0 X X X
1 0 0 X X X
1 1 0 X X X
0 0 1 X X X
SET DMX ADDRESS
Value
0～49 Sound Active mode
50～99 Auto-Beam mode
100～149 Auto-Animation mode
150～199 Manual mode to Auto run
200～255 Manual mode to Sound Active run
AL-100: closed~no blanking~moving
blanking~flash blanking~blanking
0～255 AL-600RGY: closed~red~green~yellow~
fixed color~random single color~random
three-color~moving three-color~fixed color
256 or 128 pattrens
0～127 Manual to up to down moving
Auto to down moving
128～191
192～255 Auto to up moving
0～127 Manual to left to right moving
128～191 Auto to right moving
192～255 Auto to left moving
0～127 Manual rolling
128～255 Auto rolling
0～127 Manual rolling
128～255 Auto rolling
0～127 Manual rotation
Auto clockwise rotation
128～191
Auto counter clockwise rotation
192～255
Auto zoom(+)
0～85
Auto zoom(-)
86～170
171～255 Manual zoom(+/-)
0～255 0 is Moderate, 1 is small, 255 is big
0～255 0 is display dot, 255 is best brightness
0~127 Auto drawing mode 1
128~255 Auto drawing mode 2
FUNCTION
#7 #8 #9 #10
X X X 0 SOUND ACTIVE
X X X 0 AUTO-BEAM
X X X 0 AUTO-ANIMATION
X X X 0 SLAVE MODE
1 DMX MODE
Description