Table of Contents
Advertisement
7)
INSTALLATION INSTRUCTIONS
KITCHEN UNIT / UNDERSIDE OF CABINET INSTALLATION
NOTE: Ensure that the grease filter grille has been removed.
1)
(E) – Extraction Function only If you
are using the top exhaust outlet
(meaning that you have plugged the
rear one), first cut a hole measuring
130mm in diameter in the floor of the
cupboard into which the hood will be
set (see Fig. 2, bottom centre of page)
so that the collar strip can be fastened.
2)
If necessary, make a hole for the power
cable to feed through.
3)
Hold the hood against the underside of
the hood and mark the points for the
supporting and fastening holes.
4)
Screw in the four screws supplied with
the installation accessory kit.
5)
Hook the hood onto the supporting
screws and tighten them completely
(Fig. 4 – on right). Alternatively, use
the attachment holes near the previous
ones.
__________________________
NOTE: For the Extraction fan mode, you will need to decide which exhaust port will be
used – rear or top. If you want to connect the rear one, you will need to press in the
metal cover of the top port and then cover it with the collar strip ('A' in figure 2 -
below, centre).
If you want to connect the top exhaust port, you will need to press in the metal cover
on the back and then apply the collar strip there instead ('A' in Fig. 3 – above, right).
– installing your Cooker Hood
6)
7)
6) Close the grease filter grille.
14
Advertisement
Table of Contents
