AEG DVD 4516 TFT Operation Manual page 66

Troubleshooting
Fault
No sound
The remote control
does not work
Titles are played in
wrong order
DVD cannot be
played
66
05-DVD 4516 AEG - GB Neu 66
Possible cause
During operation with a
television set:
Audio cable not connected
Amplifi er switched off
Volume turned to low
Headphones not correctly
inserted
Incorrect settings
wrong direction
too far away
Batterie empty
Playlist is used
DVD has not been fi nalized
Solution
WARNING:
Before searching for the fault, please turn the device
off.
Check the correct fi t of the Audio cable ➯ Page 50,
„Connection to Other Equipment". Make sure that the
jacks are tightly in the sockets.
If you use an amplifi er for Audio output: check whether
the amplifi er is switched on.
Press the VOLUME + button on the remote control or
keep the VOL+ button on the device pressed down for
approximately 3 seconds.
Check that the headphones are correctly positioned
➯ Page 51, „Use of ear/headphones".
Check the settings of your DVD-Player.
The remote control is not pointed towards the DVD-
Player.
Make sure that the remote control is not further than
5 m away from the player.
Replace the batteries in the remote control ➯ Page 47,
„Remote control battery installation".
Delete the playlist ➯ Page 57, „Deleting a Playlist".
Use a fi nalized DVD.
03.05.2006, 9:37:40 Uhr