Troubleshooting And Technical Data - Inalto AIH60W User Manual

Troubleshooting
\10
& Technical Data
Troubleshooting & Technical Data
Operation in case of emergency
Fault:
The lights work, however the motor
does not work
Neither the lights or the motor works
The rangehood is vibrating against the
wall
Technical data
In the event of an emergency you should:
– S
– S
– Call the Residentia Support Team on 1300 11 HELP (4357).
Some minor faults can be fixed by referring to the instructions given in the
Troubleshooting section below. There is also a self-help section online at
http://www.residentiagroup.com.au.
Important!
If your appliance appears to be operating incorrectly, then
you should disconnect it from your electrical supply and
then contact the Residentia Group Support team on
1300 11 HELP (4357).
Warning! Do not attempt to repair the rangehood yourself.
Please note that if an engineer is asked to attend whilst the product is under
warranty and finds that the problem is not the result of an appliance fault, then
you may be liable for the cost of the call out charge.
The appliance must be accessible for the engineer to perform any necessary
repair. If your appliance is installed in such a way that an engineer is concerned
that damage will be caused to the appliance or your kitchen, then they will not
complete a repair. This includes situations where the rangehood has been tiled
in or sealed in with a sealant.
Please refer to the conditions of that appear on the warranty card at the rear of
this user manual.
Common Cause:
The motor is blocked or jammed or
the capacitor is damaged.
The capacitor damaged
Beside the above mentioned, check the following:
Light globes are damaged or blown
The power cord is loose.
The rangehood canopy is not fixed to
the wall correctly.
The distance between the rangehood
and your cooktop is too great.
Electrical details Rated Voltage:
11
Common Solutions:
Call the Residentia Support team
for further guidance.
Call the Residentia Support team
for further guidance.
Replace the light globe(s)
Ensure that the rangehood is
correctly plugged in and the power
outlet is switched on.
Ensure that the internal safety
screws have been used and tight.
Have your installer re-adjust the in-
stallation position, ensuring that the
minimum distances are observed as
per the building code.
220 – 2 40 V, 50/60Hz