Related Manuals for Inalto ASL60DR2S
Summary of Contents for Inalto ASL60DR2S
- Page 1 U S E R M A N U A L I N A L T O . H O U S E 60cm & 90cm Slideout Rangehoods MODEL CODE/S A S L 6 0 D R 2 S A S L 9 0 D R 2 S F O R A L L A U S T R A L I A N H O M E S V 6 .
-
Page 2: Welcome
It is important that you read through the following use and care manual thoroughly to familiarise yourself with the installation and operation requirements of your appliance to ensure optimum performance. Again, thank you for choosing an InAlto appliance and we look forward to being of service to you. -
Page 3: Table Of Contents
24 Warranty Information Customer Care InAlto recommends the use of original spare parts. When contacting our customer service team on 1300 11 4357, please ensure that you have the following information at hand (which can be found on your appliances’ rating plate). -
Page 4: Safety Information
The following statements you will see in this This manual explains the proper use of your booklet have these meanings: new InAlto rangehood. Please read this manual carefully before using the product. WARNING: Indicating information concerning This manual should be kept in a safe place your personal safety. - Page 5 • Ensure the cooker hood is switched off before carrying out maintenance, to avoid any possibility of electric shock. • Never carry out flambé cooking under the cooker hood. • This cooker hood is not suitable for use over barbecues. •...
- Page 6 Safety Information (Continued) ELECTRICAL CONNECTION SAFETY WARNINGS – FOR THE INSTALLER Check that the mains voltage matches with When installing the cooker hood, make sure you the voltage on the data plate inside the cooker adhere to the minimum and maximum distances hood.
- Page 7 UNPACKING DISPOSAL OF THE APPLIANCE During transportation, protective packaging Old appliances should not simply be disposed was used to protect the appliance against any of with normal household waste and should damage. After unpacking, please dispose of be delivered to a collection and recycling all elements of packaging in a way that will not centre for electric and electronic equipment.
-
Page 8: Your Inalto Rangehood
Your InAlto Rangehood YOUR RANGEHOOD 40/80 Figure 3A Your Slideout Rangehood features switch controls with 2 speed levels of extraction. Figure 3B 1. Rangehood housing 2. Slide-out Front Fascia Rail 3. Inner Aluminium Grease Filter 4. Outer Aluminium Grease Filter 5. - Page 9 RANGEHOOD COMPONENTS Your InAlto Undermount Rangehood is supplied with: • 1 × Rangehood • 1 × Rear-underside support mounting bracket • 1 × 40mm Height Front Fascia Rail • 1 × Set of pre-installed Charcoal Filters (2 pcs) • 6 × Screws (ST4 × 30mm) •...
- Page 10 THIS PAGE IS INTENTIONALLY LEFT BL ANK...
-
Page 11: Operation Instructions
Operation Instructions • The rangehood will only operate once the slide-out rail is pulled outwards towards the kitchen. • Close the front panel and the rangehood will stop working. • The next time the front panel is pulled back out, the rangehood will start working at the previously set level. -
Page 12: Installation Instructions
Installation Instructions WARNING: Before starting the installation, POSITIONING THE RANGEHOOD please refer to the Safety Information section. • The typical installation method for your slideout rangehood is into a purpose built • Always switch the power off prior to overhead/wall cabinet. beginning the installation. - Page 13 ELECTRICAL CONNECTION DUCTED INSTALLATION Check that the installation complies with the Before beginning the installation of your standards of local building, gas and electrical rangehood, consider your ducting method. authorities. Before connecting your rangehood to the mains supply, ensure that the mains This rangehood has been supplied with voltage corresponds to the voltage on the expandable plastic ducting, however for...
- Page 14 Installation Instructions (Continued) • Where possible, avoid using 90 degree bends WHITE PLASTIC COVER and in their place use multiple 45 degree bends. For External Ducting, you can cover the front • Keep your total length of ducting to the outlet the white plastic cover provided in the box shortest length possible.
- Page 15 To install new charcoal filters you will need CHARCOAL FILTERS to first remove the grease filters (Figure 11). If you intend to use the rangehood with the air Then align the charcoal filters with the centre of recirculating back into the kitchen, it is important the motors, twist clockwise and push upwards that you use the charcoal filters that are already until they lock into place.
- Page 16 Installation Instructions (Continued) REAR-MOUNTING TO THE WALL • Using a spirit level, mark a horizontal line on the wall where the rangehood base will be, adhering to the minimum and maximum distances from the rangehood base to the cooktop surface (as per table on page 12). •...
- Page 17 TOP-MOUNTING IN A CABINET • Determine where in the top cabinet you want to install the rangehood, then drill 4 holes of Ø4mm at the bottom of the hanging board of your cabinet (Figure 13). Figure 13 • Install the rangehood onto the bottom of the cupboard and secure it in place with four ST4×30mm screws (Figure 14).
-
Page 18: Maintenance & Cleaning
Maintenance & Cleaning CAUTION: EXTERIOR SURFACES • Before maintenance or cleaning is carried Clean surfaces using non-abrasive cleaning out, ensure the operation and light switches products that are specifically for use on stainless are set to the ‘0’ position and the rangehood steel. - Page 19 CHANGING A LIGHT GLOBE If the light lamp needs replacing, proceed as follows: • Slide out the front panel for easier access and remove the two aluminium mesh filters • Push out the lamp by hand from its back, pull out the lamp connecting lines together; •...
-
Page 20: Troubleshooting
Troubleshooting OPERATION IN CASE OF EMERGENCY In the event of an emergency you should: • Switch off all rangehood controls. • Switch the rangehood off at the power outlet and immediately unplug. • Call After Sales Support. Some minor faults can be fixed by referring to the instructions given in the table below. IMPORTANT: If your appliance appears to be operating incorrectly, then you should disconnect it from your electrical supply and then contact After Sales Support. -
Page 21: Technical Data
Technical Data SPECIFICATIONS MODEL ASL60DR2S ASL90DR2S Dimensions 599mm × 278mm × 176mm 899mm × 278mm × 176mm (W × D × H) Extended Depth 278–472mm 278–472mm Height of Front Panel 40mm/80mm 40mm/80mm Weight 9.2kg 10.5kg Speed Settings Motor Power 2 × 100W 2 ×... -
Page 22: Your Receipt
Attach your receipt to this page... -
Page 23: Purchase Details
Purchase Details For future reference, please record the following information in the form below. The product details can be found on the rating plate (located within the rangehood, behind the aluminium grease filter), installation details and purchase details which can be found on your sales invoice. STORE DETAILS STORE NAME ADDRESS... -
Page 24: Warranty Information
Warranty Information AUSTRALIAN WARRANTY TERMS & CONDITIONS (h) ‘you’ means the purchaser of the Appliance not RANGEHOOD APPLIANCES having purchased the Appliance for re-sale, and ‘your’ has a corresponding meaning. This document sets out the terms and conditions This warranty only applies to Appliances of the product warranties for Residentia Group purchased and used in Australia and is in Appliances. - Page 25 failure. The benefits to you given by this warranty (a) the Appliance is damaged by: accident are in addition to your other rights and remedies (ii) misuse or abuse, including failure to properly under a law in relation to the Appliances or services maintain or service to which the warranty relates.
- Page 26 THIS PAGE IS INTENTIONALLY LEFT BL ANK...
- Page 27 Simply visit the below website, or ask your retailer 24 months on the microwave magnetron; Waste for help: www.inalto.co.nz/register disposers have a 12 month warranty. The provision of service under this warranty is...
- Page 28 D E S I G N E D I N M E L B O U R N E F O R A L L A U S T R A L I A N H O M E S —...