Advertisement
SI-PAC-001
3.3) Maintenance (Line) - related information
3.3.1) Checking the V-belt tension
General note
In the case of configurations with additional external alternator, inspect attachment and V-belt ten-
sion.
Checking the
Inspect V-belt tension as per drawing below.
V-belt tension
Fig. 4.
3.3.2) Adjust the V-belt tension
Belt tension
To adjust the belt tension:
Step
1
2
3
Fig. 5.
m
08 February 2019
Initial Issue
Copyright - BRP-Rotax GmbH & CO KG. All rights reserved.
Loosen the hex. screw M10 (1) and the 2 Allen screw M8 (2 and (3).
Press the alternator upwards and tighten Allen screw (3).
Then tighten Hex. screw M10 (1) with tightening torque 40 NM (30 ft.lb) and Allen
screw M8 (2) with tightening torque 22 Nm (195 in.lb).
1 Hex. screw M10
2 Allen screw M8
3 Allen screw M8
Deflection of the V-belt must not exceed 6 mm (1/4") with al load of 50 N
NOTICE
WARNUNG
(11 lb) at center.
SERVICE INSTRUCTION -
Procedure
2
PAC
1
3
00353
Page 9 of 21
.
24-30-00
Advertisement
