Zanussi ZTK 123 User Manual page 25

1 2
Selecting additional functions
You can choose from the additional func-
tions:
button 1 - DELICATE
button 2 - COTON ,
DELICATE
gentle drying with reduced heat of sensitive fabrics
and temperature-sensitive textiles (e.g. acrylic, vis-
cose) marked on care label with:
COTTONS , SYNTHETICS
type of laundry - selection for time controlled pro-
grammes
Starting the programme
Press Start/Pause button to start the dryer
after having selected the programme and the
options. The relevant light will stop flashing. If
the programme selector dial is turned to anoth-
er position, when the machine is running, the
buzzer will sound and the programme phase
indicator lights will flash. The drum turns alter-
nately in both directions during drying.
All drying programmes end with a 10 minute
cooling phase. You may remove the laundry af-
ter this phase.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again af-
ter closing the door in order to restart the pro-
gramme from the point at which it was inter-
rupted. This button must be depressed also af-
ter a power failure and after having reinserted
the water reservoir, if it has been emptied in
2) Only dryers with buzzer button
www.zanussi.com
3
SYNTHETICS
the middle of a programme after lighting up of
light Water reservoir.
In both cases the light of the
button flashes to remind you that the start but-
ton needs to be pressed again.
Indicator lights
These lights indicate the following functions:
•
Drying light: This light indicates that the
appliance is in the drying phase.
•
End of programme light: This light is
on at the end of the cooling phase, during
the anticreasing phase and at the end of the
programme.
•
Water reservoir light: This light indi-
cates that the appliance is in the drying
phase. This light comes on at the end of the
programme to remind you that the water res-
ervoir must be emptied out. If this light illumi-
nates during a programme this means that
the water reservoir is full. The buzzer sounds,
the programme stops, the light of the Start/
Pause button flashes. This light comes on al-
so when the water reservoir is not inserted
correctly.
•
Filter light: This light illuminates at the
end of the programme to remind you that the
filters must be cleaned.
•
Condenser light: It comes on every 80
cycles to remind you that the condenser
must be cleaned.
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
- OFF position. The programme is cancelled.
The programme can no longer be
changed directly once the programme has
started. If nevertheless there is an attempt to
change the programme on the programme
knob or if an function button (excluding the
2)
BUZZER button ) is pressed, led on the
START/PAUSE button starts flashing tempora-
rily in red. The drying programme is not howev-
er affected by this (laundry protection).
Start/Pause
25