Table of Contents
Advertisement
•
01 Service = Short circuit PT sensor
•
02 Service = Probe break PT sensor
•
11 Service = EEPROM - fault
11. CORRECTING A PROGRAM SETTING
The oven temperature can be altered at any time using the "-" and "+" buttons.
Modes can be changed at any time with the mode knob. If this is done the duration and end times are
retained and will only be deleted when the OFF mode is selected. Any minute minder value entered will be
retained when the oven is turned off.
The time of day cannot be entered or altered while there is a program running.
If the meat probe is removed during a program operation the current temperature program will stop.
12. DEMO MODE
For demonstration purposes, eg. for not trained person there is the facility for a demo mode. This allows all
the oven function to be demonstrated but there is no power on the heating element and the fan the oven is
not heated up.
Setting the demo mode:
The timer must be set as normal to display the time. Press the mode button and hold for about 10 seconds;
after a brief "minute minder" display the words "Demo mode no" will appear. The "+" or "-" buttons then allow
switching between "yes" and "no".
13. CLEANING AND MAINTENANCE
Thoroughly clean the oven before operating it for the first time and after every use, thus avoiding baking in of
residual food stuffs. After residues have baked in several times, they are then difficult to remove. Never
clean the oven surfaces by steam cleaning.
Cleaning operations must be carried out only when the equipment get cold.
Outer parts of the oven should only be cleaned with warm soapy water using either a sponge or soft cloth.
No abrasive cleaners should be used.
Removable roof liner (only for Megachef 3M)
In those models supplied with traditional grill it has been set a removable roof liner which allows a better
cleaning of the upper part of the oven. It is possible to extract it from the cavity as it slides over the grill
element. When this liner is cleaned it is advisable to place it back on its housing.
Replacing the lamp
The oven must always be disconnected from the mains when you're going to replace an oven part.
With a tool remove the lamp cover and replace the lamp. At the end of this operation place the cover again
on its centre.
14. ACCESSORIES
In order to provide a better cooking, the ovens are equipped with the following elements:
•
2 Safety grill shelves;
•
Removable side racks;
•
2 drip trays;
•
1 handle trivet;
•
1 rotisserie spit with its own holder.
15. TECHNICAL SERVICE
The appliance must always be disconnected from the mains when being repaired.
If you cannot find any reason for the malfunction:
12
Advertisement
Table of Contents
