FUTABA T8FG Series Manual page 66

example to describe mixing rate setting. The mixing
at this position.
*The sub-trim function can be used to make small
helicopter achieves maximum pitch.
mode.
1. Adjusting the aileron operation [AIL to PIT]
Adjust the AIL to PIT rate so there is no binding
in the elevator or pitch movement when the
aileron stick is moved to the left and right.
2. Adjusting the elevator operation [ELE to AIL]/
[ELE to PIT]
Adjust the ELE to AIL and ELE to PIT rates so
there is no binding in the aileron or pitch
movement when the elevator stick is moved
up and down.
3. Adjusting the pitch operation [PIT to AIL][PIT
to ELE]
Adjust the PIT to AIL and PIT to ELE rates so
that the swash plate moves to the level/
horizontal position when the throttle stick was
moved to maximum low and full high.
high pitch.
66
* niet vertaald *
to the data input mode. Touch the RTN button to end
1. Compensating aileron input [AIL]
Set the throttle to the lowest position. Move
the aileron stick to the left and right and
adjust the aileron compensation amount
so that interference in the elevator or pitch
direction is minimal.
direction [DIR.] as "-".
2. Compensating elevator input [ELE]
Adjust the elevator compensation amount
s o t h a t t h e a i l e r o n o r p i t c h d i r e c t i o n
interference when the elevator stick was
moved up and down is minimal.
3. Repeat steps 1 and 2 above, perform aileron
and elevator compensation similarly at full
throttle.
1. Move the cursor to the "SPEED" item and
touch the RTN button to switch to the data
input mode.
2. Set the throttle stick to the neutral point
adjust the speed compensation amount
[SPEED] for minimum interference in the pitch
direction.
Touch the RTN button to end adjustment and
return to the cursor mode.