Table of Contents
Advertisement
6. D/R function
each condition.
mentioned "Throttle/Pitch curve setting"
maximum
sensitivity minimum
driven helicopter, this function may not have
any effect on the high gyro sensitivity.
Note: When using a GY601, GY502, GY520,
GY401, or other heading hold gyro, this
Pitch to RUD mixing should not be used. The
reaction torque is corrected by the gyro.
When operating the gyro in the AVCS mode,
the mixed signal will cause neutral deviation
symptoms and the gyro will not operate
normally.
and speed of the main rotor during pitch operation.
to rudder mixing.
* niet vertaald *
A curve setting example is shown below.
Use the hovering system and set this curve to
match take off and landing and vertical climb at a
constant speed.
Use this curve in 540º stall turn, loop, and rolling stall
turn, and adjust it so the fuselage is facing straight
ahead when heading into the wind.
This function is set so that the fuselage is facing
straight ahead at straight line auto rotation. The
pitch of the tail rotor becomes nearly 0º.
at idle. The action is not functional at high throttle
binding.
corresponding to each operation of each condition.
39
Advertisement
Table of Contents
