Advertisement
Installing hole plugs
Locate hole plugs in the small bag supplied
with washer instruction guides. Cut them apart
from each other and insert them in the holes in
washer back panel.
Leveling your washer
Excessive noise and vibration can be
prevented by properly leveling the washer.
1. For free standing
installation and with
the washer within 4
feet (1 m) of its final
location, place a level
on top of the washer.
2. Use adjustable
pliers or the universal
wrench to adjust
the leveling legs so
the washer is level
front-to-rear and side-
to-side, and stable
corner-to-corner.
3. Press down on
alternate corners and
sides and feel for the
slightest movement.
Adjust the appropri-
ate leg(s) so the
washer sits solidly
on the floor on ALL
four legs. Keep the
leveling leg extension
at a minimum for best
performance of the washer.
Installation Instructions
Connecting inlet water
1. Run some water from
the hot and cold faucets
to flush the water lines
and remove particles that
might clog the water valve
screens and to determine
which faucet is hot and
which is cold supply.
Rubber Washers
Must Be Present
NOTE
Hoses are not included with washer pur-
chase. See "Accessories" section for various
inlet hose kits to fit your specific installation.
2. Connect the
HOT inlet hose
to the HOT
inlet connection
on the washer
and the COLD
inlet hose to
the COLD inlet
connection on
the washer.
Tighten by hand
until snug. Then
tighten each
supply connec-
tion another 2/3
turn with pliers.
Do not cross thread or over-tighten
these connections.
USE ONLY
NEW HOSES
9
Advertisement
