System Board - HP Pavilion x360 Convertible PC Maintenance And Service Manual

Reverse this procedure to install the TouchPad.

System board

Table 5-9 TouchPad description and spare part number information
Description
System board equipped with an Intel Pentium N5000 1.10-GHz (SC turbo up to 2.70-GHz) quad core
●
processor (2400-MHz FSB, 4.0-MB L2 cache, 6 W), an Intel UHD Graphics 605 graphics subsystem
with UMA memory, and the Windows 10 operating system (includes processor and replacement
thermal material)
Before removing the system board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the solid-state drive (see
When replacing the system board, be sure to remove the following components from the defective system
board and install them on the replacement system board:
WLAN module (see
●
Heat sink (see
●
Memory shield (see
●
USB/audio board cable (see
●
Remove the system board:
1. Disconnect the following cables:
(1) Power connector cable
(2) Webcam/microphone module ZIF connector cable
(3) Display panel ZIF connector cable
(4) WLAN antenna cable
(5) Speaker cable
(6) TouchPad ZIF connector cable
(7) Keyboard ZIF connector cable
Bottom cover on page
Battery on page
Solid-state drive on page
WLAN module on page
Heat sink on page 37)
Memory shield on page
USB/audio board cable on page
23).
25).
29).
30)
39)
40)
Spare part number
L52048-601
Component replacement procedures 35