Solid-State Drive - HP Pavilion x360 Convertible PC Maintenance And Service Manual

Solid-state drive

Table 5-5 Solid-state drive description and spare part number information
Description
256-GB, PCIe, NVMe solid-state drive
128-GB, M.2, SATA-3, solid-state drive with TLC
Solid-state drive shield
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×2.2 broad head screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling it away from the slot.
Reverse this procedure to reassemble and install the solid-state drive.
Bottom cover on page 23).
Battery on page 25).
Component replacement procedures
Spare part number
L52050-001
L52441-001
L52441-001
29