Cutting A Hole And Mounting Installation Plate - Toshiba MMK-UP0151HP-E Installation Manual

5
CUTTING A HOLE AND MOUNTING INSTALLATION
PLATE
Cutting a hole
In case of installing the refrigerant pipes from the
rear:
1. Decide the hole position for piping at
180 mm from the arrow mark ( ) on the
installation plate and drill a hole at a slight
downward slant toward outdoor side. Pipe
hole; dia.65 mm: P015- P018 type Pipe
hole; dia.80 mm: P024 type
80
65
1111012101
The center of the pipe hole is above the arrow.
NOTE
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe
hole brim ring sold separately.
Mounting the installation plate
Anchor bolt holes
Hook
300
85
Hook
Pipe hole
Thread
Indoor unit
80
65
1111012101
23 mm
Pipe hole
dia. 65 mm:
P015- P018 type
dia. 80 mm:
P024 type
180 mm
110
120
170
132
23
Pipe hole
Hook
(dia. 65 mm
dia. 80 mm)
Mounting
screw Installation
plate
Weight
When the installation plate is
directly mounted on the wall
wall by screwing it in the upper and lower
parts to hook up the indoor unit.
2. To mount the installation plate on a
concrete wall with anchor bolts, utilize
the anchor bolt holes as illustrated in the
3. Install the installation plate horizontally in
the wall.
When installing the installation plate with a
mounting screw, do not use the anchor bolt
hole. Otherwise the unit may fall down and
result in personal injury and property damage.
NO OK NO
GOOD GOOD
5 mm dia. hole
Clip anchor
(local parts)
Failure to firmly install the unit may result in
personal injury and property damage if the unit
falls.
• In case of block, brick, concrete or similar type
walls, make 5 mm dia. holes in the wall.
• Insert clip anchors for appropriate mounting
screws.
NOTE
• Secure four corners and lower parts of the
installation plate with 6 mounting screws to
install it.
14
Installation Manual
CAUTION
Anchor bolt
Projection
15 mm or less
Mounting screw
∅ s
CAUTION
14-EN