Applicable Controls - Toshiba MMK-UP0151HP-E Installation Manual

11

APPLICABLE CONTROLS

REQUIREMENT
When the air conditioner is used for the fi rst
time, it will take some moments after the power
has been turned on before the remote controller
becomes available for operations: This is normal
and is not indicative of trouble.
Concerning the automatic addresses
•
(The automatic addresses are set up by
performing operations on the outdoor interface
circuit board.)
While the automatic addresses are being
set up, no remote controller operations can
be performed. Setup takes up to 10 minutes
(usually about 5 minutes).
When the power is turned on after automatically
•
address setup, It takes up to 10 minutes (usually
about 3 minute) for the outdoor unit to start
operating after the power has been turned on.
Before the air conditioner was shipped from the
factory, all units are set to [STANDARD] (factory
default). If necessary, change the indoor unit
settings.
The settings are changed by operating the wired
remote controller.
* The settings cannot be changed using only a
wireless remote controller and simple remote
controller by itself so install a wired remote
controller separately as well.
Applicable controls setup
■
(settings at the site)
Remote controller model name:
RBC-ASC11E
Basic procedure
Be sure to stop the air conditioner before
making settings.
(Change the setup while the air conditioner is not
working.)
CAUTION
Set only the Code No. shown in the following
table: Do NOT set any other Code No.
If a Code No. not listed is set, it may not be
possible to operate the air conditioner or other
trouble with the product may result.
1
Push and hold menu button and [
setting button simultaneously for
10 seconds or more.
After a while, the display fl ashes as shown
•
in the fi gure. "ALL" is displayed as indoor
unit numbers during initial communication
immediately after the power has been
turned on.
Indoor unit No.
2
Each time [
is pushed, indoor unit numbers in
the group control change cyclically.
Select the indoor unit to change
settings for.
The fan of the selected indoor unit runs.
•
The indoor unit can be confi rmed for which
to change settings.
3
Push OFF timer button to confi rm the
selected indoor unit.
Set data
4
Push the menu button to make
Code No. [
[ ] with [
5
Push the menu button to make Set
data [
[ ] with [
– 30 –
Installation Manual
] [ ] setting button
Code No.
] fl ash. Change Code No.
] [ ] setting button.
] fl ash. Change Set data
] [ ] setting button.
]
30-EN