Indoor Unit; Installation Place; Cutting A Hole And Mounting Installation Plate - Toshiba RAS-25S4KVPG-ND Installation Manual

Installation Place

• A place which provides the spaces around the indoor unit as shown in the
diagram.
• A place where there are no obstacles near the air inlet and outlet.
• A place which allows easy installation of the piping to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed at least 2.5 m height. Also, it must be
avoided to put anything on the top of the indoor unit.
CAUTION
• Direct sunlight to the indoor unit's wireless receiver should be avoided.
• The microprocessor in the indoor unit should not be too close to RF
noise sources.
(For details, see the owner's manual.)
Remote controller
• A place where there are no obstacles such as a curtain that may block the
signal from the indoor unit.
• Do not install the remote controller in a place exposed to direct sunlight or
close to a heating source such as a stove.
• Keep the remote controller at least 1 m apart from the nearest TV set or
stereo equipment. (This is necessary to prevent image disturbances or
noise interference.)
• The location of the remote controller should be determined as shown
below.
(Side view)

Indoor unit

7 m
Remote
controller
Cutting a Hole and Mounting
Installation Plate
Cutting a hole
When installing the refrigerant pipes from the rear.
To the center of the pipe hole
1. After determining the pipe hole position on the mounting plate ( ), drill
the pipe hole (Ø65 mm) at a slight downward slant to the outdoor side.
NOTE
• When drilling a wall that contains a metal lath, wire lath or metal plate,
be sure to use a pipe hole brim ring sold separately.
INDOOR UNIT INDOOR UNIT
(Top view)
Indoor unit
Remote
controller
Pipe hole
Ø65 mm
130 mm
Mounting the installation plate
Indoor unit outline
300
170
65
Hook
Pipe hole
Drain hose position Thread
Directly mounting indoor unit to the wall
preparation
• In the case of block, brick, concrete or similar type wall, determining the
mount screw position on the wall can be used position as below for drill
hole to insert clip anchors for appropriate mounting screw.
95
Top of installation plate
• The provided screws should be used to fi x the indoor unit directly to the
wall at the predetermined position.
6
Mounting screw
Space allows under the indoor unit
• Space allows for moving range of the air inlet grille and horizontal louver
in operation above curtain rails, window cornice or other objects.
Air inlet grille
Distance between
bottom of indoor unit
to maximum horizontal
louver opening
Distance between
Horizontal louver
bottom of indoor unit
to maximum the air inlet
grille opening
CAUTION
• If have curtain rails, window cornice or other objects, allow space from
the indoor unit should be 55 mm or more.
• If allow space is less than 55 mm, this can affect the opening and
closing of the air inlet grille and the horizontal louver.
• However, there should be no objects in the air outlet position.
It will block the air fl ow direction and drop performance.
7
Recommended mounting
screw positions (Unit : mm)
Hook
300
170
65
Hook
Pipe hole
Weight Drain hose position
(Unit : mm)
20
Installation plate
Indoor unit
460
(Unit : mm)
Curtain rails,
window cornice
170
or other objects
EN
ES
FR
IT
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI