Hoover PRB2500B User Manual page 7

Turn the temperature dial (10) to your desired setting, the iron light (10) illuminates , meaning the soleplate
heating up. After approximately 2.5 minutes, the steam ready light (14) will light off, then you can start ironing.
Important:
if you want to switch from Dry mode to Steam mode, press steam ON/OFF button and wait around 2min for
boiler heating up then press trigger, steam will come out.
if you want to switch from Steam mode to Dry mode, press steam ON/OFF button, you will see the light behind
the button is off, then no steam will come out.
N.B.
The first time the appliance is used, some fumes, dust and a smell should appear.
It's quite normal and will quickly disappear.
This is due to a treatment applied to the soleplate that improves the steam performance.
Before use, please use the iron as described in Chapter 2.4 Vertical Steam Ironing.
Chapter 2: Using Your Steam generator
Chapter 2.1: Regulating the Soleplate Temperature
Select the temperature of the soleplate by turning the dial (12) on the iron to the desired position.
Wait a few moments until the iron light (10) is off.
This indicates that the soleplate has reached the required temperature.
While Ironing, the Iron light may switch on and off, this indicates that the temperature is
being Adjusted automatically to maintain temperature so as not to interrup your ironing.
Help
To know the best suitable temperature for each textile, check the laundry care label of the article to be ironed.
Please note that during use, the temperature light goes on from time to time. It signifies that the iron is heating
up to the set temperature.
When ironing material with mixed fabrics, always ensure the temperature is set to the correct setting.
If you select a lower temperature while ironing, wait until the iron has cooled down to the set temperature
before you continue ironing.
If the temperature is too low, some drops of water could escape from the soleplate. Please raise up the
temperature above the 2 dots (••) to avoid this issue.
Chapter 2.2 - Ironing
Dry Ironing
Select the temperature of the soleplate following the indications of chapter
2.1. Start your ironing without pressing the steam ON/OFF button (15), when
the soleplate reaches the appropriate temperature.
Steam Ironing
Select the temperature of the soleplate following the indications of chapter
2.1. The steam will be ready to be used after press "steam ON/OFF" button,
when steam ready light (14) disappear. From that time you can
begin ironing and use the steam trigger. The steam flow stops
when you release the trigger.
N.B.
During use, it is normal to experience some noise coming from your steam generator. It signifies that a pump
injects water into the boiler. It's better to avoid using the steam trigger at this precise moment to avoid
pressure falls.
5 GB
Fig. 6: Pressing Steam Trigger graphic