Hitachi SF-250ZFVAD Instruction Manual page 7

How to Install the Washing Machine
Installing the drain hose
● The symbol is for checking whether you install the washing machine correctly.
1. Push the drain hose into the connection port and hold it tightly with the hose clip (enclosed in the
package.)
 Hose clip (set it correctly in the direction indicated in the fi gure)
2. Insert the end of the drain hose into the drain outlet.
 Do not allow the drain hose to be bent, twisted, pulled out and damaged, stepped on, or crimped.
 Spread a cloth on the ground before laying the washing machine down on its back to prevent damaging it.
 Use a knife to cut the end of the drain hose at a 45 degree angle because if the drain channel is shallow
and the end of the drain hose is blocked, it could cause a malfunction.
 Is it fi rmly installed to the drain outlet, elbow
pipe connector and drain trap?
 Is the end of the drain hose blocked?
 Is the hose piece installed to the end of the
drain hose?
 Is the drain hose bent?
 Keep the top of the drain hose no more than 10 cm above the fl oor if it crosses a door sill or something
else. If it is higher than this, the water has diffi culty draining and a "C2" error (water does not drain) may
occur.
 Do not extend the drain hose more than 2 meters from the washing machine.
 Please use the Extension Hose that is sold separately. For good draining eff ect, please follow below.
In case of using the general extension hose, if inner diameter of hose is small, it cannot drain water
effi ciently and the unit may not work normally.
 Is the end of the drain hose coming off due to
the force or vibration of the drainage water?
 Is the height of the drain hose exceeding more
than 10 cm and the total length of the drain
hose exceeding more than 2 m?
Connection
port
Drain hose
Internal hose
Connection port
Drain Outlet
Bent
10 cm or less
Base
Base
Hose clip
Drain Hose
Blocked
Hose Piece
2 m or less
Drain Hose
7