Bang & Olufsen BeoCom 1 User Manual page 32

32
Note that if you have an active call
and switch to the non-active line
without placing the active call on
hold first, the active call is ended!
If you have incoming calls on both
lines at the same time, press a line
key to select a line before
answering a call.
If you have kept a call on hold for
over three minutes, the handset
then beeps once every thirty
seconds to remind you of the call
on hold. A call kept on hold for ten
minutes is automatically ended.
Placing the handset in the charger
does not end calls placed on hold.
>> 2-line use
Switch between calls on separate lines
BeoCom 1 makes it possible for you to handle simultaneous calls on
separate lines. The display shows which line is active and whether
or not a call on the other line is placed on hold.
To handle two simultaneous calls on separate lines...
1:John Smith
Time: 0:35
2:David Jones
5551212
HOLD
2:David Jones
555121
LINE 2
LINE 1
You have an active call on line 1
The display and a dampened ringing signal from
the handset loudspeaker inform you of an
incoming call on line 2
Press to put the active call on hold. In this
example, the display indicates that there is a call
on hold on line 1 and an incoming call on line 2.
If you want to end the active call before
answering the incoming call, skip this step
Answer the incoming call on line 2
Press to end the active call
You can then press the appropriate line key to
resume the call on hold