Bang & Olufsen BeoLab 3 User Manual page 7

LEFT
1
Cable Clamp: For safety reasons,
the mains lead must be secured to
the loudspeaker. Use the enclosed
small cable clamp and screw.
RIGHT LEFT
2
Power Link cables: The enclosed
Power Link cables are of a new
type. The new type has a triangular
mark on the plug.
Do not use any cables of the older
type, as this will cause noise, and
therefore not give optimum sound
quality!
Power Link connections: These
connections carry both the right
and left sound signals. There fore,
the cables may be run in two ways:
1 Run a Power Link cable from the
RIGHT
Bang & Olufsen system directly
to each loudspeaker.
Or
2 Use a Power Link adapter (optional
accessory, available from your
Bang & Olufsen retailer). Run a
cable from the Bang & Olufsen
system to the fi rst loudspeaker,
Power Link
and then run another cable from
Mk 3
the fi rst loudspeaker to the next
(this will often minimize cable
clutter).
7