Summary of Contents for Bang & Olufsen Beolab 4000 MKII 6642
Page 1
BeoLab 4000 MKII Type 6642, 6643, 6644, 6645, 6646, 6647, 6648 Service Manual English German, French, Italian, Spanish, Danish, Dutch and Japanese versions are available in the Retail System This Service Manual must be returned with the defective parts/back-up suitcase !
CONTENTS Survey of modules ..............1.1 How to service ................1.2 Warnings – Insulation test ............2.1 Adjustments ................3.1 Repaie tips ................4.1 Replacement of modules ............5.1 Specification guidelines for service use ........6.1 Block diagram ................7.1 Wiring diagram .................
How to service How to service Front line service BeoLab 4000 MKII is to be serviced in the customer’s home when it comes to electrical symptoms or exchange of mechanical parts. In this way you avoid having to make more than one visit and using minimum of time on the case, all for the benefit of the customer.
Warnings – Insulation test Warnings When electrical replacement or disassembly is taking place, use an ESD-mat. The internal electronics are very sensitive to static electricity. ESD-Mat Handling Wear cotton gloves to avoid any fingerprints on the product. The surfaces on the product are very sensitive, so handling should be done with great care to avoid damage.
Adjustments Adjustments Adjustments after replacing PCB03, Main PCB Read out the adjustment position of the old potentiometers, R301 & R312, and set the new potentiometers to the same position. Adjustments of bass/treble levels Each loudspeaker is individually adjusted from production to ensure optimal stereo perspective. When replacing a speaker unit or PCB03, Main PCB, bass/treble levels have to be adjusted.
Repair tips Repair tips Hum in loudspeaker when no music is played The Power Link cable must be of type MK III or higher. The ground connection in Power Link cable lower than MK III may be insufficient for optimum sound performance. Power Link MK III Check loudspeaker units...
Replacement of modules Replacement of modules Modules that can be replaced BeoLab 4000 MKII in service position ......5.2 Replace PCB0, Amplifier .......... 5.4 Replace PCB02, SMPS ..........5.5 Replace PCB03, Main PCB ......... 5.6 Replace PCB04, LED ........... 5.7 Warning –...
BeoLab 4000 MKII in service position - Remove cables connected to BeoLab 4000 MKII LINE POWER LINK - Remove front frame - Remove profile TX10 - Remove screws for baffle TX10...
Page 11
BeoLab 4000 MKII in service position - Remove cables for speaker units...
Replace PCB03, Main PCB + 5.2 BeoLab 4000 MKII in service position - Remove screws and pull out PCB03, Main PCB - Remove ground cable! TX10 Ground - Remove cables 3P300 3P103 3P100...
Replace PCB04, LED + 5.2 BeoLab 4000 MKII in service position - Remove screw and pull out LED TX10 - Remove screws and pull PCB04, LED out TX10 - Remove screw and pull off light guide TX10...
Specification guidelines for service use Specification guidelines for service use BeoLab 4000 MKII Type 6642 (EU), 6643 (GB), 6644 (US), 6645 (J), 6646 (AUS), 6647 (KOR) 6648 (CN) Power supply: Voltage 100-240 Volt Power consumption Typical: 6 W, Standby: 0.5 W Cabinet finish Grey, black, dark grey, yellow, red/black, blue/black Front cloth...