Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bang & Olufsen BeoLab 1
Summary of Contents for Bang & Olufsen BeoLab 1
- Page 1 BeoLab 1 User’s guide...
- Page 2 Legal notice: CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No User-serviceable parts inside. Refer servicing to qualified service personnel. WARNING: To prevent fire or electric shock, do not expose this appliance to rain or moisture.
- Page 3 Likewise, the guide gives some advice on how to place the BeoLab 1. Contents of the Guide How to set up the BeoLab 1 loudspeaker 4 Before you start… NOTE! We urge you to read this part before you start assembling your loudspeakers.
-
Page 4: Before You Start
(pages 6–7). • On the top of the BeoLab 1 is a small recess. This is for ventilation of the powerful BeoLab 1 amplifiers. Do not cover up this recess (and do not use it as ‘a carrying handle’... - Page 5 Fasten the base with the six screws provided. Rubber feet adjustment: To compensate for an uneven floor surface the BeoLab 1 base plate has been fitted with six adjustable rubber feet (indicated by the little arrows).
- Page 6 • Connect one BeoLab 1 loudspeaker to your system as previously described, e.g. the left- hand speaker. • Make a connection from the first BeoLab 1 to the other one, using the second Power Link socket. You may connect more than one pair of BeoLab 1 speakers to your system (as many as ten pairs, in fact).
- Page 7 The phono socket marked LINE must be used instead of the Power Link sockets if the BeoLab 1 is to be connected to a non- Bang & Olufsen product (using e.g. a cable, part no. 6270595). The signal must be on a regulated low-voltage level.
- Page 8 BeoLab 1, and thus the surroundings. Which switch position to choose depends on the distance from the BeoLab 1 to the walls and corners of the room. The Speaker Position switch has three settings: •...
- Page 9 Speaker Position: IN CORNER AGAINST WALL FREESTANDING ~ 40 cm 16" ~ 130 cm 51" Example 1: The loudspeakers are placed in one end of the room (but not against the wall), and not near the side walls. Thus, the Speaker Position switch should be set to FREESTANDING on both the left- and right-hand loudspeaker.
-
Page 10: Daily Use
BeoLab 1 speakers are not in use. If the BeoLab 1 speakers are connected to a non-Bang & Olufsen system – via the phono socket (LINE) – they switch on automatically when a signal is received from the system. - Page 11 NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may...