Page 2
WARNING: To reduce the For the US-market only! This device complies with part 15 risk of fire or electric shock, NOTE: This equipment has been of the FCC rules. Operation is do not expose this tested and found to comply with subject to the following two appliance to rain or moisture.
Daily use When you have finished setting Indicator Switching on and off – up the loudspeakers as described indicator light on the following pages, When you switch on your Bang & connect the entire system to Olufsen system, the loudspeakers the mains supply. When in switch on simultaneously.
Set up the loudspeakers We recommend that you follow Cautions this procedure: – Make sure that the loudspeakers – Disconnect your system from the are placed and connected in mains supply. accordance with the instructions – Place the loudspeakers according in this Guide.
Connections and settings Switches Power Link sockets The loudspeakers can be used with Bang & Olufsen audio, video and link systems. They may also be used with non- Bang & Olufsen systems. The loudspeakers are designed for wall placement. The most natural sound is obtained if they are set up as explained on these pages.
Page 6
20 cm place the wall bracket as follows: – BeoLab 12–2: 59–165 cm distance from the loudspeaker to (8"). Shown by the black areas in the walls and corners of the room.
Waste Electrical and Electronic electrical and electronic equipment Your Bang & Olufsen retailer will Equipment (WEEE) – and batteries by use of the collection advise you of the correct way of Environmental protection systems available in your country, disposal in your country. Electrical and electronic you protect the environment, human equipment, parts and...
Need help?
Do you have a question about the BeoLab 12 and is the answer not in the manual?
Questions and answers