Electric Connection; A) Aerial Connection; B) Connecting The Audio Output Aux Out - Renkforce DAB+ RF-DAB-CAR1 Operating Instructions Manual

9. Electric Connection

No lines must be installed in the airbag trigger area because this may cause injury
to the vehicle passengers in case of accident.
When laying the cables, make sure that they are not squeezed or scoured on
sharp edges. Use rubber grommets for the feed-though points.
You should only use a voltmeter or a diode test lamp for checking the voltage of the
on-board cables, as normal test lamps consume excessive currents and can thus
damage the electronics system of the car.
After connection, the connection cables can be fixed to the dashboard or
gooseneck using the cable ties supplied.
On the back of the gooseneck mounting plate are cable clamps that can also be
used to fix the connection cables.

a) Aerial Connection

• Connect the aerial plug of the enclosed DAB aerial to the aerial connector (8) of the car
receiver.

b) Connecting the Audio Output AUX OUT

If you want to transmit sound to the car radio via an audio line and your car radio has an audio
input (usually labeled AUX IN), please proceed as described in the following paragraph.
This connection is of better quality than audio transmission using the built-in FM transmitter.
Only connect the device with suitable shielded connection cables. Use of any
other cables may cause interferences.
Keep the length of the cables as short as possible.
Do not place the cables near other cables to avoid interferences in the cables.
• Connect the audio output AUX OUT (10) to the audio input of your car radio.
• Use a suitable 3.5 mm jack cable.
34